Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
It sounds like your factory brake controller on your 2012 Ram 3500 is at the end of it's life, or that it isn't compatible with an EOH brake configuration even though it is supposed to be. One other thing you can do to double check, is to set…
view full answer...Although I would not be able to speak on the installation of the part(s) you received for your trailer, I can tell you that the TremPro 644 Silicone Sealant part #0160297 will do an excellent job of sealing your new aluminum panel to the trailer and…
view full answer...We have similar hubs to the Dexter #8-231-9UC1-EZ you referenced with the 9/16 inch wheel studs with the part #AKIHUB-865-7-1-EZ-K but we don't have anything from Dexter. I attached a review video for this hub for you to check out as well.
view full answer...You will need to measure the diameter of the spindles where the seal and bearings ride. Check out the picture I attached that shows where this is. You will need an exact measurement so either a digital or dial caliper will be needed. To pick out the…
view full answer...The Kodiak Disc Brake Kit #K2R712E is designed to work on idler hubs exactly like the Trailer Hub Assembly #8-231-9UC1-EZ that you referenced. These parts are totally compatible with each other and I can assure you that the spacing between the…
view full answer...The easiest solution I may have for you would be to use a triple axle brake line kit like the #20TR-BLKIT or #HS496-253 and route everything like the picture I attached.
view full answer...The difference between the two trailer hubs you referenced part #8-231-9UC1-EZ and #42865-KIT is that the #42865-KIT comes with two different grease cap styles and the #8-231-9UC1-EZ only comes with one, the EZ lube style that has a rubber plug that…
view full answer...You will need to remove the existing trailer hub from your axle to be able to find the correct hub and drum assembly replacement for your trailer. The things you will need to know are listed below. Inner Bearing Part Number Outer Bearing Part Number…
view full answer...I can help you correctly run hydraulic lines on your trailer. Adding disc brakes is a great idea, but the reason you are having such difficulty finding a schematic is because hydraulic brakes are rarely installed on 5th wheel trailers and they are…
view full answer...The HydraStar Disc Brake Kit w/ Actuator for Triple Axle Trailers - 13" Rotor - 8 on 6-1/2 - 7K #HSE7K-TR1SO will work great on your 2020 Grand Design Momentum 376THS with 7k triple axles but this is a slip on kit so you will need idler hubs as…
view full answer...Having the slightly larger main feed line of 1/4 inch is a a great idea for plumbing up your triple axle trailer. We have the HydraStar kit part #HS496-153 which is designed for that. This kit uses 1/4 for the main feed line to the first tee fitting…
view full answer...Yes, the Trailer Hub Assembly #42865-KIT and the Trailer Hub & Drum Assembly #42866UC3 would work well together for having a brake axle and an idler axle. The both have the same bolt patterns, weight capacities, and use the same bearings so they…
view full answer...Related Searches
Filter Your Search
Contact and Help