Search: demco ez latch coupler   >   !Brake Actuator   >  

I was able to go out to our warehouse and measure the face plate on the Bauer Products Camper Door Lock #BA65FR. The face plate is 5-1/2" tall and 5-7/8" wide.

Yes, the correct replacement door latch kit you'd want is the Global Link RV Entry Door Locking Latch Kit with Keyed Alike Option #295-000019. This matches the exact type of latch that you sent in a picture of. I attached a review video for…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…

There is! To replace the standard pin and clip on the Curt QuickPin No Latch A-Frame Trailer Coupler #C84DR Curt actually recommend the Hitch Lock #C23025 which is what I recommend going with!

There typically aren't any part numbers stamped onto the trailer spindle that can be used for identification. There are however numbers stamped onto the hub most times which can be used for identification. The TDE46210 tells me you have a…

We have just what you are looking for. I called my contact at TDE and asked about the hub you have on your boat trailer. They told me that it was a 5-stud idler hub for a 3,500-lb axle. That means you need the part #AKIHUB-545-35-K. This is a fit for…

The Demco coupler #DM16680-52 you were looking at does not include the hardware needed for installation. It would be a good idea to switch over from your weld on to a bolt on coupler, this will make it a whole lot easier to replace over time as it…

To install the Demco A-Frame Trailer Coupler #DM16680-52 that you referenced, you will want to use 3/8 inch, grade 5 bolts , approximately 1-1/2 inches long (depending on how you are installing the coupler). You will want to use 5 of these bolts per…

I do have an option for you and this is a common question but the trailer coupler repairs kits aren't universal and only a very few available for select trailer couplers. Therefore, if you're having issue with your existing coupler it will…

I would be happy to help you. I recommend the Demco 50-Degree A-Frame Trailer Coupler w/ Jack Hole and Anchors, eZ-Latch - 2-5/16" Ball - 21K item #DM16680-52. The Demco eZ-Latch mechanism will give you a simple, secure hookup, and disconnect.…

Correct, there will need to be a small amount of wiggle room or play between the trailer coupler and hitch ball which is to allow the trailer to track and turn smoothly. If the connection point between the trailer coupler and hitch ball was too tight…

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…