Search: curt ball mount only   >  

Yes you sure can! The replacement pins that are used to adjust the hitch ball and pintle hook on the Curt #C45910-15-20 are found on our site listed as part #C45925. If you would rather go with a locking pic set I recommend the Curt Lock Set #C23556.…

The only difference between the Optronics ThinLine LED Trailer Tail Light part #STL87RCB and part #STL87RCPG is that the latter has bullet style (removable) connectors and the former has bare wire ends.

Yes, the Thule One-Key System Lock Cylinders part #TH450400 will work with the Thule Canyon XT Roof Cargo Basket part #TH859XT and allow you to secure it to your vehicle. All you will need to do is pop off the plastic covers on the mounting clamps…

I wasn't able to cross-reference these numbers but if you're looking for new bearings/races and seals all you need to do is note the capacity or measure. The easiest method would be to crawl under the trailer and look for the axle tag on the…

We carry several trailer hitch locks that could work for you (see link), like the part #e98881 which is a very popular option that we offer.

In order to avoid cutting into the bumper of your 2018 Honda Odyssey you would want Curt hitch #C13370. This is a Class III hitch with a 2" receiver and maximum towing capacity of 3,500 lbs. This hitch is not going to require any cutting…

The Curt Towing Starter Kit for 2" Hitches - 2" Ball - 3/4" Rise, 2" Drop - 7.5K #C45534 as it comes is ready to be used in the 2 inch drop position. You can absolutely remove the hitch ball and flip the ball mount upside down and…

The majority of standard hitch balls with a 1-7/8" diameter will have a 2,000-3,500 lb weight capacity. If you need a hitch ball with a 1-7/8" diameter that has a 5,000 lb weight capacity then you will need to use a pintle hitch ball. For…

The Curt Adjustable 2-Ball Mount #C99NR uses Pins #C56NR which are 3/4" in diameter and have a usable length of 3-3/4". You will need the InfiniteRule Lock #IR36FR which is also 3/4" in diameter with a 3-7/8" span to lock the…

There isn't a specific fit for your 2006 Ford Super Duty Cab and Chassis. You would need to use the B&W Turnoverball Underbed Gooseneck Trailer Hitch for Flatbed Trucks - 30,000 lbs #BWGNRK1500 and weld custom for your truck. Another option…

It sounds like you are asking about the distance from the center of the hitch pin hole to the back of the shank of the ball mount that slides into the hitch. That distance is 2-1/2 inches. I attached a picture that shows this dimension as well.

On the Curt Ball Mount #C45090 the distance from the center of the hitch pin hole to the near edge of the reinforcing gusset is 3-inches. From the hole center to the end of the shank the measure is 2-1/2-inches. I prepared a photo diagram for you to…