Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Robert, so for base plates that are going to be compatible with both your Gladiator and your Wrangler I'd recommend going with the Roadmaster Direct-Connect Base Plate Kit #RM-521453-5. These are going to be direct connect base plates…
view full answer...I spoke with my contact at Optronics about the 5-Way to 7-Way part #A57CCB and the dimensions are: Stretched length of cable from plug to plug is 94.5 inches 5-way flat plug to coil is 17 inches 7-way round plug to coil is 7 inches Coil length is 8…
view full answer...Here is a list of the different bulb and socket kits we currently offer. Roadmaster Tail Light Wiring Kit with Bulbs #RM-155 Blue Ox Tail Light Wiring Kit - Bulb and Socket #BX8869 Roadmaster Tail Light Wiring Kit w/ 7-Way to 6-Wire Connector - LED…
view full answer...If your 2009 Toyota Tacoma has the factory 7-Way connector at the rear of your vehicle the factory brake controller port is located underneath and left of the steering column, taped to another harness near the emergency brake pedal. There will be a…
view full answer...Outboard and In-board fifth wheel rail kits have the same strength ratings. Basically either kit is as going to be as strong as any fifth wheel hitch that fits the rails. The pros of the outboard kits like #RP56001-53 are an easier install, whereas…
view full answer...You're correct. The repalcement for your existing B12EA-22 brake would be #AKEBRK-7R-SA for the right side and #AKEBRK-7L-SA for the left.
view full answer...The SAE-P2-A98 that you are referring to is actually tied to different tests that have been done on the light and doesn't reflect the part number of the light itself. We have found that a good number of customers have replaced lights with…
view full answer...Hello again Mark. I checked with Curt and the USCAR #C56229 uses 14 gauge wire for every wire but the 12v line. The 12v line is 12 gauge.
view full answer...You link to #C59HR, the Curt Tow Bar Extension Cord w/ Socket. This connects the 7-way, blade-style connector from an RV to the 6-way round connector used for towed vehicles. This drops the black wire, the battery hot lead.
view full answer...Yes, you can utilize the unused 12v pin on your 7 way and 6 way plug in order to keep your towed vehicle's battery topped off. Keep in mind, this will only act as a battery maintainer / tender but it will not charge a completely dead battery.…
view full answer...Yes, as long as your Jayco 2022 Class C Redhawk 26 XD already has a charge line then adding the Roadmaster Battery Charge Line Kit for Towed Vehicles #RM-156-25 to the toad will allow you to use the Curt Tow Bar Extension Cord w/ Socket #C59HR to…
view full answer...The Replacement Hub Assembly for Demco Kar Kaddy #DM04369 is the only hub assembly we have for the Kar Kaddy's. There is no 5 on 4 bolt pattern, you likely already have a 5 on 4-1/2 bolt pattern. I recommend double checking the measurements.…
view full answer...Filter Your Search
Contact and Help