Search: c45070   >  

The U-Haul 5x8 Cargo Trailer has a suggested coupler height of 18". Therefore, you'll want to take this measurement and subtract this from the distance from the ground to the top inside edge of the receiver on the vehicle. The difference…

The etrailer.com Trailer Hitch Receiver part #E98841 when we installed it on a 2013 Hyundai Santa Fe was 13" from the ground to the top inside edge of the receiver tube. I called U-Haul and they said that the coupler height of the 4x8 cargo…

The Curt Class III hitch, part #C13416 is the easiest to install hitch we offer for your RAV4. The majority of the hitch will be concealed behind the bumper, which many folks seem to prefer. If you'll be towing with the hitch, you'll need a…

The UFP H-1377 correlates to a Dexter #84 spindle, which is for a 3,500 pound axle. This will utilize an inner bearing #L68149 and an outer bearing #L44649. As this is being used on a boat trailer, I highly suggest going with the etrailer.com…

I can help you pick out the correct hub, but we don't have a cross-reference part number for the one you listed. In order to pick out the correct hub assembly for a trailer you are going to need know a few key pieces of information. The first…

We do not carry the Glo-Brite brand of trailer light (and I believe they are no longer in business) but we do have a replacement for the model 1250. My research indicates this amber lens light measures 6-1/2-inches x 2-5/16-inches, like the part…

The Honda sensor kit you're talking about is a relocation kit so the hands-free liftgate will function as normal with a hitch installed. You can install either the Curt #C13421 or Draw-Tite #76290 hitch on your 2022 Honda Passport and it…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The heating element on your Atwood model GC10A-4E water heater (our part #AT94022) should be on the backside of the unit, towards the bottom of the tank. It will actually be behind the gas line assembly, which will need to be loosened and moved out…

I sent all of your info and pictures to MaxxAir to find out what circuit board you'd need and they told me the board you need is the part #MA10A21275K.

My contact at MaxxAir advised that there are three potential causes for the beep and no fan motion you're experiencing with your MaxxFan Trailer Roof Vent #MA00-04000K. One potential cause is that the unit was wired with incorrect polarity. Make…

I've attached the owners manual for your 4900K model which is similar to the #MA00-04500K model. It sounds like your operator mechanism is bad according to my tech contact at MaxxAir. For your 4900K model you will want the Replacement Operator…