Search: boat trailer winch trailer winch   >   Trailer Winch   >  

The size winch that you will need depends on a couple of different factors. I have included part of our hand winch FAQ below regarding boat winches and have linked the FAQ article for you to view. Finding the Right Capacity Winch for your Boat…

Hi Bob, So the load rating really depends on what kind of set up you have when loading your boat. You mentioned bunks, and if those are wooden bunks, that's going to make it much tougher to get the boat on, and you'd want a winch with a 1:1…

The Dexter Heavy Duty Suspension Kit #K71-360-00 has equalizers are 7 inches from bolt hole center to center and 5-3/4 inches bolt center to center. This kit when used with double eye springs like #e64SR will give you the 33 inch on center axle…

We have one double-eye leaf spring that has a 7,000 lb axle rating. For that you would want the part #e64SR. The hanger kit you would need then to go with that is the Dexter Heavy Duty kit part #K71-360-00. The axle spacing will be 33 inches which is…

The best tire we have in the size ST235/80R16 that you referenced would be the #TTWTRTM2358016E. This radial tire is a Load Range E with a 3,520 lbs at 80 psi capacity and a speed rating of 81 miles per hour. Normally trailer tires are only rated for…

To get the best braking power for your boat trailer you would want to have disc brakes on both axles. If you happen to be limited to one axle then you would want the rear outfitted. With a 5,000lb boat you likely have two 3,500lb torsion axles. The…

The Dutton-Lainson Covered Hand Winch #DL17085 is 13-1/2" long/wide when looking at the side. I added a review video of this winch that shows more of its measurements for your to check out.

Hey Bill, so if it was me I would go with the Dutton Lainson winch part #DL17085 over the Fulton. I really like DL winches because they are well made, very reliable, and made in the USA. Fulton winches aren't terrible but DL winches win if for…

The Dutton Lainson StrongArm Winch part #DL24874 (also known as the SA12000), can have a strap or cable attached to it. What you described is how you would replace the cable with a 2 inch strap for this winch.

Since your main concern is the marks on the hull of your boat I recommend going to the Yates TPR Ribbed Wobble Roller. These rollers are constructed of thermal-plasticized rubber which is a non-marking, non-scratching material. It is stronger and…

I have attached a link to a helpful article that explains how to choose the correct winch for a boat trailer. Here is what the article says: Finding the Right Capacity Winch for your Boat Trailer. Boat-size-to-winch capacity is generally 2 to 1 With…

Yes, you could remove the inner member of the Dexter DX7.5L A-60 to replace the bad member of your UFP A-60. Our pricing algorithm can be a little confusing so if this is the less expensive route than just the inner member part #DX99FR it is what I…