Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
You have 2 options for your 25 Ft 4-Way Trailer Wiring Harness #A25W2GWB when wiring in the Optronics LED Combination Trailer Tail Lights #TLL160RK. First is the way I recommend since the harness has the full length ground wires is to cut off the…
view full answer...This Submersible LED Trailer Light Kit with 25 foot Wiring Harness, part #TLL9RK, uses all stainless steel mounting hardware. The mounting hardware of this trailer light kit should work well in the saltwater conditions that you use your boat in.
view full answer...The brown (running light) wires all run to each other as they carry the same circuit. The reason there is two browns on the trailer side is because there are running lights that are on both sides of the trailer. Aside from that all the rest of the…
view full answer...The submersible LED trailer light kit part #TLL9RK is designed to be backed into water like when installed on a boat trailer. We still recommend unplugging the trailer wiring just because water and electricity don't like to mix well. We are aware…
view full answer...I went out to the warehouse and pulled the Waterproof, Under 80 inch LED Trailer Light Kit, item #TLL9RK, to see exactly what Optronics means by waterproof. Upon initial inspection the housing itself is not water tight. Water can access the housing…
view full answer...We offer part #107-30A from C E Smith which includes cap nuts and measures 5/8-inches in diameter by 19-inches in length. You can use this item and cut it down to the required length for your specific application.
view full answer...I did some searching on the Internet and if you wanted to, there is a way to use the integrated brake controller that is in your 2011 Chevy 3500 with an electric over hydraulic system. The first thing you will need to do is connect the 12 volt power…
view full answer...Like you said, many factory integrated brake controllers will not work well with electric over hydraulic trailer braking systems. Some of the newer versions of these controllers now have an electric over hydraulic mode. Check to see if any of your…
view full answer...You may need to adjust the output setting on the factory brake controller on your 2011 GMC Sierra HD. I also assume that the adapter you are using is #T4845900 which is the correct model to plug in with the Titan BrakeRite I Plug and Play…
view full answer...The breakaway battery used with the Titan BrakeRite EHB Electric-Hydraulic Actuator #T4813102 that you referenced must have at least 12 amp hours. The battery will be mounted on the trailer. For a kit that includes both breakaway batteries needed you…
view full answer...I spoke with my contact at Tekonsha, who is doubtful the controller is the issue. The voltage from the controlleer that's sent to the actuator is very minimal, it's just telling the actuator when and how hard to fire. The actuator is actually…
view full answer...It will fit Bargman part #40-06-001. Since your light is a Bargman unit, you will just need to find the part number on it somewhere. The DOT 97 number has to do with Department of Transportation regulations and you will see similar numbers stamped on…
view full answer...Filter Your Search
Contact and Help