Result: boat trailer brake kit

Yes, the mounting brackets included with the DeeMaxx Disc Brake Kit #DE72FR are also stainless steel.

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

On your 2004 Ford F-350 the factory port to plug in a brake controller is located near the center console to the right of the steering column. I have linked a video that shows how to access it.

So you'd have to change out everything, including the brake mounting flange, as the 6-bolt is simply not used anymore. There isn't a direct replacement from Dexter, so you'd need a 5-bolt brake mounting flange welded on (assuming you have…

For your 2004 Ford F-350 diesel I recommend the P2 #90885 with wiring harness #3035-P. The P2 is one of our most popular brake controllers of all time because it is easy to set up and use and it is reliable. This is a proportional controller that…

The correct size nuts for the brake mounting flange bolts you have on your trailer is going to depend on which bolts you have. There is not really a standard thread pitch for braking assemblies so it will be best to replace the nuts and bolts with…

The disc brakes you need will be determined by the weight of your axles (not the total capacity of your trailer), the size of your brake mounting flange (4-bolt most common), and the rotor diameter of your disc brakes. The best way to find the weight…

The only difference between 7-Way Utility and 7-Way RV is the color of the wires. The pin outs are the exact same so either would work just fine with the other. If you check out the picture I attached you'll see that the functions are all the…

It's a wire color difference but not a function difference on the pins of the 7-way. The difference comes from the fact that the two different styles are representative of two different areas that uses trailers. Traditional is usually seen on…

There are grease seals with inner diameters of 1.687 inches, #168255TB, or 1.688 inches, #168233, that would be a better fit. If the outer diameters match the inner hub bore diameter then you can use one of them instead. Seal #168255TB has an inner…

The bearings and seals needed for the Titan Premier Disc Brake Kit #T2HRCM10DAC are sold separately. You'd need the #L68149, #L44649 and for a seal part #RG06-050 and you'd be set.

The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-20 is a direct replacement for your Tie Down model 70E disc brake actuator with a 7000 lb capacity (Tie Down was bought out by Dexter back in 2017). Although I don't have a way of decoding your…