Result: bl7023582

While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the 1.6" ID and 2.5" OD measurements you provides, that is very close to our #58846. This particular grease…

There is no specific torque rating when reinstalling the castle nut after packing the bearings. You want to run the nut down until there is no side to side play in the hub, and then back it off to the next notch in the castle nut so the retainer can…

The recommended lug nut torque for your 7,000lb axle depends on a few factors like wheel size, stud size etc. Check out the attached photo which shows the torque specs for a variety of applications. I see you were looking at the Dexter Nev-R-Adjust…

The AL-KO trailer hub part number 8700 that you have is a 3,500 lb trailer hub/drum with a 5 on 4-1/2 inch bolt pattern. Based on that the #AKHD-545-35-EZ-K is the correct fit and would work great.

We have a really great kit that comes with everything you'd need to convert your 2021 Vanleigh Pinecrest 335RLP from tandem 6k drum brakes to electric over hydraulic disc brakes with the HydraStar Disc Brake Kit w/ Actuator for Triple Axle…

I have attached for you below the recommended procedure to flat-tow a 2019 Jeep Cherokee Trailhawk per the owner's manual. The last step states to place the ignition in the off position so that is what I must recommend. 1. Bring the vehicle to a…

The B and W Tow n Stow part #BWTS20048B has two pin holes. The closest pin hole the ball center measures 9-1/4 inches whereas the further pin hole measures 10-3/8 inches.

Hitch pins don't actually bear any of the weight of the trailer so they are not rated for trailer weight like what you are referencing. The tongue weight of the trailer pushes so hard down on the hitch tube that it binds it up in the hitch…

We definitely have some trailer jacks you can use as a replacement for your Dutton-Lainson but it doesn't look like anything we have will work as a direct replacement. If you'd like to stick with the Dutton-Lainson brand then I recommend…

Using the cut off wiring harness you have for the P3 part #90195 you will wire it to the brake controller wiring of your 2023 Ford Ranger which is sticking out of the large wire harness that goes through the driver's side firewall, left of the…

To install a p3 brake controller part #90195 in a 2015 Dodge Durango you'd need to use the part #TK93VR which plugs into the port under the dash of your vehicle without requiring additional wiring. If you check out the install video I attached at…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…