Result: bearing l68149 trailer bearings races seals caps

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

I have included some images with the dimensions of both the Gen-Y Hitch Shock Absorbing 5th Wheel to Gooseneck Pin Box #GY58GR and a 1621 Pin Box #LC1191151. Hopefully these images with measurements will help you find the measurement you are looking…

Thanks for the picture! That is exactly what I need to confirm what pin box your Forest River Shasta Phoenix 28RB has. I just spoke with my rep at Lippert and you have a 1621 pin box with an 18,000 lbs capacity. You will want the Gen-Y Hitch 5th…

If the axle tag on the trailer does not include the axle capacity then you'll have to pull the hubs and either measure the bearings and seals or record their part numbers. The most common bearing combo is a L68149 (1.378" inner diameter) and…

The grease seal you have would indicate you have a 3,500 lb trailer axle. So for a bearing kit you'd want the #BK2-100 and you'd be set.

The shortest hitch ball that will fit the GM factory puck system is the Curt item #C60627. The overall height of the Curt Pop-In Ball is 7-7/8" and the installed height is 5-1/8". This hitch ball is also available with the safety chain…

The Trailer Hub and Drum Assembly part #AKHD-545-35-K can indeed be used with bearing buddies. These hubs will have a 1.98" hub bore diameter. In order to be sure there are no issues you'll want to be sure your hub bore diameter matches…

Yes the 4,000-lb leaf spring is compatible with a 3,500-lb axle. There are a couple of important measurements. Spacing from eye to eye on the spring when unloaded with no weight on the axle. Inner eye diameter of the spring roll Spring width from…

In order to determine whether or not the Dexter Trailer Axle Beam with 4" Drop part #7685269 will be a good replacement for your Marine Master Boat Trailer Axle we would need to know the distance between the hub faces and spring centers on the…

Because the zerk fitting is a press fit, if they are falling out I would recommend simply leaving them out and replacing your existing grease caps with bearing protectors like Bearing Buddies. The Bearing Buddies you need will depend on your hub…

The E-Z Lube grease zerks are threaded in, and if you can remove your zerk with the threads not damaged, people have had success replacing it with the Replacement Grease Zerk #Gzerk. The zerks have a standard 1/4" pipe thread fitting which is…

If the Erickson ATV E-Track Tie-Down Kit w/ Ratchet Straps and Wheel Chocks #EM98CV are all coming loose, there is definitely something odd going on. First thing you will need to check is the release levers. You will need to make sure they are not…