Search: b&w tow & stow   >   Trailer Hitch Ball   >  

It sounds like you are trying to decide between the B&W Tow & Stow 3-Ball Mount part #BWTS20049B which has 7" of drop and the B&W Tow & Stow 3-Ball Mount part #BWTS20048B which has…

The B&W silencer pad, part #BWTS35025, fits all of the 2-1/2 inch B&W Tow & Stow ball mounts, like part #BWTS20049B as an example. With that being said, since trailer hitch pin holes aren't all at the…

The Yakima Replacement Anchor Plate Style-A, Part #Y8810074, comes as a set of 8 plates that measure 3/4-inch x 7/8-inch. The centered threaded hole measures 0.2 inches (or 5.1 millimeters) in diameter. Please refer to the photo provided. The…

Tracks can absolutely be installed on the roof of your A.R.E. Truck Cap to provide a mounting system for a roof rack. For this I recommend the Yakima Tracks, which come in 42 inch #Y01126, 54 inch #Y01127, and 60 inch #Y01135 lengths. These tracks…

For your Aluma 6810 HBT trailer, I recommend the Erickson Horizontal E-Track - Zinc Coated Steel - 2,000 lbs - 5' Long - Qty 1 #E19148 along with the E-Track Backing Plate - Zinc Plated Steel - 6" Long x 6" Wide #e96RR. This…

Since you have an aluminum trailer I suggest using a tie-down that has a backing plate like #RR5K. This will help reinforce the tie-down since aluminum may not hold up. It would be even better if you can install the tie-downs to the frame of the…

I have attached for you below some common torque values needed for a trailer suspension system but a lot of these will vary by bolt size and other factors. U-Bolts: Varies by Size - 1/2" bolts: 45 ft/lbs - 70 ft/lbs, 9/16" bolts: 65…

It sounds like you just want to know the difference in size and load ratings between ST235/80R16 and ST235/85R16 radial trailer tires. When fully inflated a ST235/80R16 radial trailer tire like the Provider #TTWTRTM2358016E will measure…

On a trailer electric brake assembly like the Dexter 6,000 Pound #23-105 you were looking at the magnet itself should be at the bottom. The arm that is attached to the magnet should then be located on the front side of the trailer (towards the…

I recommend using the CE Smith U-Bolt #CE15501A because it is stainless steel, measures 2-1/8" wide x 4" long, and it includes the washers and nuts you need for the installation. Ultimately you will still get galvanic corrosion over…

The Curt Adjustable 2-Ball Mount #C99NR uses Pins #C56NR which are 3/4" in diameter and have a usable length of 3-3/4". You will need the InfiniteRule Lock #IR36FR which is also 3/4" in diameter with a 3-7/8" span…

On each individual electric brake magnet the amperage draw would be 3.0 to 3.2 max amps at 12 to 13 volts on 7-inch brake magnets and 3.2 to 4.0 max amps at 12 to 13 volts on 10 and 12-inch brake magnets. The max amperage draw for the brake magnets…