Search: TS10048B   >  

Normally the SAE number isn't a reliable way to pick out replacement lenses, but we know that the #A32RB is the correct replacement for a lens marked SAE-A-P2-DOT-02 like what you have. For an all new assembly you'd want the part #MC32RB.

Thanks for the picture. I went ahead and checked out what we have that matches that style of plug, and unfortunately we do not have anything that matches what you are needing. The closest 3-prong wire we have is the 3-Wire Pigtail for Trailer Tail…

I am happy to verify for you that your 2023 Nissan Frontier Pro 4X is 100% compatible with the Draw-Tite front hitch that fits, which is the following part number: - Draw-Tite Front Mount Trailer Hitch Receiver #65075 So you will have no issues…

There is no specific torque rating when reinstalling the castle nut after packing the bearings. You want to run the nut down until there is no side to side play in the hub, and then back it off to the next notch in the castle nut so the retainer can…

I recommend going with a wheel like the Taskmaster Modular Wheel in White #TA36MR or Silver #TA35ZR. These wheels only have a 0.08" positive offset keeping the center of the Provider 235/75R17.5 Radial Trailer Tire #P35175 in line with the…

Sounds like you have a bit of corrosion on the brake output pin of the 7-way you have on your tow vehicle. Try cleaning the pin in the 5:00 position and should see that issue go away. When a trailer senses an amperage draw (which corrosion will…

You can absolutely trust the manufacturer ratings for the ball mounts we have available, regardless of whether or not they feature a solid or hollow shank. Ball mounts and other towing products are typically tested well beyond their actual listed…

Ideally you want bunk boards that are at least 50% of the length of your boat, and want the to run from the stern and as far forward as you like. Since your boat is 16' Long you will want at least 8' of bunk boards, but I recommend going with…

Two 12 foot long bunks boards will work well to support your 21 foot boat. Ideally, the bunk boards should be at least half as long as your boat and run from the stern (or a few inches beyond it) to the bow as far forward as you like. Due to shipping…

The connector you sent in a picture of is not the brake controller port. You would want to look for the female style plug that would match the connector in the picture I submitted. We have had customers state that the location of the brake controller…

I attached a picture of the installation instruction page from the Dutton-Lainson Electrical Quick Connect #DL24086 that you referenced. It looks like you will need to cut the wires and strip the wires back 1/2 of an inch. Next you will need to put…

From my research the hub and rotor assembly you're looking for is for a 3,500 pound axle with a 5 on 4-1/2 bolt pattern. It uses bearings #L68149 and #L44649 and has a Dacromet finish for marine use. If the bearing numbers match you can use…