Result: TRU46FR

The Tru Ryde grease seals you mentioned, part #RG06-70 are indeed a replacement for the 10-036-00 Dexter seals. They would work great for your application.

The correct replacement leaf spring bushings for any given trailer will be dependent on the width and type of the leaf springs. The most common for a Dexter 10,000 lb Trailer Axle are 3" wide slipper springs. If you have 3" wide slipper…

We have the 3/4" Conical Washer #3232 and 3/4" Bolt #090747 that is 4-1/2" long. There is also the 3/4" Nut #F2135823295 with the same 16 threads per inch as the bolt.

It sounds like you have an equalizer bolt like part #7-136-2-6-112 as opposed to one with a hex head like the part #7-169-6-112. This is fine as long as the diameter and length matches what you're needing. When installing suspension bolts on your…

For the right hand side 18-3/8 inch long equalizer for 2-1/2 inch wide slipper springs you can use #13-140-3. It can actually be used as a left or a right.

We do have a compatible grease seal for your 168255TC oil seal, however, we do not carry rubber coated seals in this size. The 168255TC oil seal was designed to work with oil bath hubs on a 3,500 lb axle. For the most part, axle manufacturers have…

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

The Dexter "8-256" is a hub assembly that uses an L68149 inner bearing and a L44649 outer bearing. This hub assembly was offered in a few different bolt patterns therefore you would need to confirm your bolt pattern using the attached help…

In order to get your steps back up and running you are going to need to install the update kit, the Motor Upgrade Kit for Kwikee 26 Series Electric RV Steps part #LC379801. The update kit is your only option because they no longer offer a replacement…

It sounds like you're looking for the Extension Cord for ComeUp Winch Hardwired Remotes #CU882843. This extension measures 16" long and will work great with your Badlands winch since they both use a 6-pin connector. If you needed a longer…

If you are looking for the center section of the bracket that is in the picture you submitted of the #MCL67ARB that you referenced the correct part number you need is the #A65P that you referenced.

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…