Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The most popular trailer wheel bolt pattern is the 5 on 4-1/2 inch bolt pattern and as far as we are aware the bolt pattern you mentioned is not used on trailers at all. So my bet is you probably have the 5 on 4-1/2 inch. I attached a help article…
view full answer...The appropriate torque spec for any application will vary depending on the construction of the wheel as well as on the stud size. I suggest checking the wheels you're using to see if their manufacturer has a suggested torque rating. Steel trailer…
view full answer...To replace your NOK AD2527E seal you can use #168233. It has an inner diameter of 1.688 inches and an outer diameter of 2.332 inches. Based on what I could find on the NOK AD2527E the inner diameter is the same and the outer diameter is 2.328 inches.…
view full answer...It sounds like you're looking for replacement brakes for your 12,000 lb Moritz dump trailer. From what I have found, this trailer uses tandem 6,000 lb axles. Based on that information, I recommend the Dexter Nev-R-Adjust Electric Trailer Brake…
view full answer...The recommended distance between the hangers of the #APS1 would be 24-7/8 inches when using the leaf spring #e54SR. When the trailer is set on the ground and the leaf spring is supporting the weight of the trailer the spring will flatten out and get…
view full answer...I did not find anything on a HP54VK trailer fender, If you meant the #HP54VR Tandem Axle Teardrop Trailer Fenders, we do not have a custom fit fender backing plate that fits the #HP54VR. However, we do have the Backing Plate for Tandem Axle Trailer…
view full answer...I attached a chart that has the automotive cross reference for the Kodiak disc brake pads part #K2250CP that you referenced under the yellow heading. Probably the easiest to look up would be 1982 to 1992 Chevy Cavalier.
view full answer...It appears that the #84 E-Z Lube Spindle #TRU87FR is the correct spindle for your axle. You can confirm that this is the correct part by verifying the measurements of the spindle and brake flange. The landing for the grease seal is 1.719, the inner…
view full answer...The Dexter Trailer Axle #7685269-EB you found uses a #84 E-Z Lube Spindle #TRU87FR. It requires the Trailer Spindle Jam Nut #6-191 with a Washer #5-23 and Retainer #6-190.
view full answer...The #84 E-Z Lube Spindle with Brake Flange for 3,500-lb Trailer Axles - 4" Drop part #TRU87FR is designed for a 3,500 lb axle with a 2-3/8" outer diameter. I don't have a list of every trailer that the spindle will fit but so long as…
view full answer...A #84 spindle is the standard 3,500 lb axle spindle. It uses an inner bearing L68149 (1.378" inner diameter), and an outer bearing L44649 (1.063" inner diameter). These days this is basically universal for 3,500 lb axles. What you have with…
view full answer...The brake mounting bolt pattern for the #84 E-Z Lube Spindle w/ Brake Flange for 3,500-lb Trailer Axles #TRU87FR is 2-13/16" and then the section that fits into the axle tube is 2" and it tapers out to 2-3/8". Attached are dimensional…
view full answer...Related Searches