Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
I did some looking and found that the 46210 and 46845 hubs you currently have use the same #L68149 inner bearing and #L44649 outer bearing. However, as we do not carry the Tie Down Engineering Vortex hubs, I cannot say what all will fit them,…
view full answer...The correct replacement trailer clearance light for a Bargman 99 Series is the Optronics Trailer Clearance or Side Marker Light part #MC44RB for red or part #MC44AB or amber. The mounting holes for this light are spaced 3" apart on center.…
view full answer...For your Glo-Brite 118A amber light the replacement lens that will fit is the Optronics #A44AB; the lights themselves are the Optronics #MC44AB. The Glo-Brite 117R can use replacement lens #A44RB while the light is #MC44RB. I've added links…
view full answer...I did some research and found that the 12194TC seal you said you have measures 1.250 inside diameter, and 1.979 outside diameter. The seal I recommend is part #34823. The dimensions listed for this seal are 1.249 inside diameter and 1.983 outside…
view full answer...The Optronics light that you referenced, part #ST70RB, is an exact replacement for Bargman light #40-06-001. If you can find that part number on your Bargman light, then we can be sure that this light is the correct replacement. Even if your Bargman…
view full answer...The correct replacements we offer for the Glo Brite Marker Lights 118A and 117R is the Trailer Clearance or Side Marker Light part #MC44AB for amber and part #MC44RB for red.
view full answer...It sounds like you have the older hub 22834 that is no longer in production that takes the outer bearing of part #1779 and inner bearing of part #2788. I was not able to find any other bearings that measure .093" inner diameter besides 1779 or…
view full answer...The most likely cause for the turn signals not to work when the running lights are on with your trailer is a bad or weak ground. It's very possible that a weak ground connection can be just strong enough to allow sufficient current for some…
view full answer...You will first want to check the fuses on your tow vehicle. Some vehicles could have fuses for operating the turn signals and brake lights of a towing package. You will want to check if they are installed and working properly. The next thing is to…
view full answer...The Timbren Rear Suspension Enhancement System #TDVRRT on your 2012 Dodge Grand Caravan do ride close to the axle, but your photo seems closer than normal. We have had some folks mention that when unloaded the Timbren springs ride pretty rough and…
view full answer...I checked with Curt and the correct brake controller wiring harness adapter needed to install a Curt trailer brake controller like the Curt Echo Under-Dash Trailer Brake Controller part #C27JR which is what I recommend on a 2019 Volkswagen Atlas is…
view full answer...It looks like the lock is on a bed topper/camper shell or a custom utility bed. Without being able to see the entire lock cylinder removed from the assembly to see how it connects to the actuating arm for the lock, I couldn't say if any of the…
view full answer...Filter Your Search
Contact and Help