Search: MCL44AB1   >  

For an LED replacement that is nearly identical to the Wesbar 105826 light you can use #STL36RB for the right side and #STL37RB for the left side. There are also versions that have a plug instead of just bare wires. For the right side use #STL36RPG…

The SAE number you provided in your question isn't always the most accurate way to determine a correct replacement assembly. This is simply because it does not refer to the actual light part number, but to various safety guidelines that it meets.…

We can get you a good replacement, though there is actually no longer a TDE brand. But that actuator is simply a bolt-on, 7,500 lb actuator that couples to a 2" hitch ball, and per the owner's manual does not have a lockout (so it is for…

With a one wire light like the Optronics Mini Rectangular LED Clearance Light, item #MCL95AB, you can ground the light in one of two ways. If the light is mounted to a location that allows for the mounting bolt or screw to contact a good ground…

It sounds like you have the older hub 22834 that is no longer in production that takes the outer bearing of part #1779 and inner bearing of part #2788. I was not able to find any other bearings that measure .093" inner diameter besides 1779 or…

It sounds like the light on your trailer is either missing a wire or it was only designated for one tail light function. If the light does not look old or damaged, I would guess that it is just a clearance light and should be connected to the running…

For light requirements you have to look at the total length and width of the trailer along with its gross capacity. The 1987 Coleman Sequoia is 14 feet, 11 inches long and 6 feet, 8 inches wide. That makes the trailer right at 80 inches wide, but…

The lighting on your 1987 camper van used a single power wire input and would ground the lamp through the lights mounting bracket. This is how the Optronics LED Trailer Clearance and Side Marker Light #MCL44AB1 would connect. The Optronics LED…

You're not going to have any problems mixing Dexter and Lippert components on trailer axles over 10k-lbs in the same manner as below 10k-lbs as long as the measurements on the replacement parts are the same- i.e. bearing sizes are the same, etc..…

The Timbren Rear Suspension Enhancement System #TDVRRT on your 2012 Dodge Grand Caravan do ride close to the axle, but your photo seems closer than normal. We have had some folks mention that when unloaded the Timbren springs ride pretty rough and…

I checked with Curt and the correct brake controller wiring harness adapter needed to install a Curt trailer brake controller like the Curt Echo Under-Dash Trailer Brake Controller part #C27JR which is what I recommend on a 2019 Volkswagen Atlas is…

The fact your outer bearing fits on a .75 diameter spindle means we aren't going to have a standard bearing kit to fit since that's not a standard dimension. Can you get me the C dimension as well? It could be that you need the part #LM67048…