Result: HappiJac

Hey Eric, thanks for all of the info on your setup. Yes, the Torklift Camper Tie Down kit part #TL76NR comes with the correct two tie down kits you mentioned for your 2021 GMC Sierra 1500 short bed without running boards.

The distance between bolts on the HappiJac #LC182496 Jack System, measured center-on-center is 7-1/4" inches and 17" overall length. I have attached a drawing with measurements.

Yes the tie down plates part #LC182876 that you referenced do fit your 1989 Ford F-250 since the correct part number tie down for your truck is #LC182910.

Thanks for reaching out and the info on your 2006 Rage'N Falcon 3405 Toy Hauler! Since it has a GVWR of 14,000 lbs this means you likely have 6K axles and can use the 12" Dexter Nev-R-Adjust Electric Trailer Brake Kit #23-458-459 (one kit…

I contacted the Rep at Happijac to inquire on your question of the HappiJac Swing-Out Extender Bracket for Dual Wheel Chassis Truck Camper Jacks, #HJ54FR. His response was that yes, you can "stack" the extensions. There is however a point…

Hi Mark, thanks for the question and yes, the Brophy Slide In Camper Tie-Downs #HSAB for your 2024 Ram 3500 are sturdy enough for your Lance 825 slide-in camper. These will work so long as you do not have the RamBoxes in your truck, and while the…

Yes you can absolutely use the HappiJac Qwik-Load Turnbuckles for Camper Tie-Downs #LC182895 with your TorkLift tie downs.

Yes I confirmed with TorkLift that those were the correct fitting tie-downs for your 2020 GMC Sierra 1500 with 6.5' bed without board underneath bed and factory installed hitch with dual exhausts. So you'll need the TorkLift Custom…

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

The Replacement Remote Control for HappiJac #LC723915 is the replacement remote compatible with the Replacement Circuit Board for HappiJac #LC733513. HappiJac has two remotes, one is compatible with the older circuit boards that have a 20 amp fuse.…

The Brophy Clamp On Camper Tie-Downs #HSAB typically are not a fit for dual rear wheels since they angle down closely to the body of the truck. With dual rear wheels your fenders stick out quite a bit eating into the space where the #HSAB would sit.…

The Brophy Clamp On Camper Tie-Downs #HSWB that you referenced are designed to clamp over the bed rails and looking at pictures online of the dually model for your 2017 Ram 3500 I think the extended/protruded wheel wells on the truck are going to…