Search: Cam door Latch   >  

Yes, the Dexter BrakeRite Electric Over Hydraulic Actuator for Disc Brakes #DX82KR can be used with drum brakes when it's used with the Drum Brake Reducer, but unfortunately the pressure can't be adjusted.

The Solera Rollbar Only For 18' White Awning, Grey Tube #LC338512405 is a universal replacement for power and manual Solera awnings. However, if you are unsure of what brand or size awning you have, there are a couple ways to find out what…

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

The Unitized Oil Seal #10-63 is the correct replacement oil seal for the phle ap3137n2 oil seal that you have. If you want to switch to a grease hub you will need the Grease Seal #GS-2250DL.

It sounds like you need to re-calibrate the zero point on your Lippert Ground Control 3.0 #LC304136 system. Below I've listed out the steps you'll need to follow and will allow you to use the auto leveling again. Zero Point Calibration The…

The hinge you referenced part #PLR2212-AS would replace what you have now on your horse trailer and the holes would line up. It looks like for your window you'd need a piano hinge that's about 2 feet long, but at this time we do not have any…

On the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 4-Point Set #LC358590 the best thing to do to check you level is to recalibrate your system. You do this by resetting your zero point. See the attached…

I am happy to verify for you that your 2023 Nissan Frontier Pro 4X is 100% compatible with the Draw-Tite front hitch that fits, which is the following part number: - Draw-Tite Front Mount Trailer Hitch Receiver #65075 So you will have no issues…

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

I can confirm that the correct part for you is the Replacement Lippert Components Correct Track Weld-On Axle Hanger #LC303918. When I reached out to Lippert they told me this hanger measured exactly 4.93 inches long x 3 inches wide x 3.3 inches.

If everything is still in good shape there's no need to replace it. The springs sometimes last a very long time. But if you wore out the rubber rin the EZ Flex it's time for a new kit as the rubber is not replaceable. Based on your trailers…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…