Search: Break Away Switch   >  

Hey Glenn, yes the Roadmaster Falcon tow bar part #RM-522 will work great with a Roadmaster base plate kit. This is the tow bar I recommend the most with Roadmaster base plate kits actually.

Hi Garry; we have exactly what you are looking for regarding wiring for your 2015 Kia Soul for flat towing: - Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit #RM-15267 - Roadmaster Battery Charge Line Kit for Towed Vehicles #RM-156-25

Fulton's snap-ring jacks like the #FTJ120W0301 are going to top out at 1,200lbs and the 1,500LB Jack #F141132 you found has a bolt-thru design and is not offered in a snap ring. We do offer the 2,000LB Jack #TJB-2002S-B which would fit…

Hey Joe, I have the following component recommendations for your 2023 Jeep Grand Cherokee L Overland: Baseplate: Blue Ox Base Plate Kit #BLU68CR Tow Bar: Blue Ox Avail Non-Binding Tow Bar #BX7420, This will also include safety cables so you…

Yes, it will so long as your older model Falcon All Terrain Non-Binding Tow Bar item #RM-522 has the attachment on the ends of the arms like the picture below. If you don't have these we can get you set up with a pair of new ones using the…

Although it's not said, to install the Demco Tabless Base Plate Kit #DM77YV there may be some trimming of spoiler, air dam, grille or plastic fascia required depending on the model of this vehicle. To complete your flat towing setup,…

It sounds like you are asking about connecting the breakaway switch of the Brake Buddy Classic 3 Portable Supplemental Braking System #HM39494. I cut out some pages from the instruction manual for you to check out, but what you'll do is…

To attach the Blue Ox 6-Pole Connector #BX294-0902 to the now discontinued Blue Ox BX1721 Base Plate on your 2021 Chevy Colorado you will need to use #12-14 x 1" self drilling screws which you can pick up from a local home improvement store.…

You can absolutely wire up a 3-wire breakaway switch like the Hopkins LED Breakaway Switch with 7" Lead Wires #HM20059 to replace your 2-wire switch; the difference is that the 3-wire switch has a dedicated ground wire while the 2-wire…

I believe you are looking for the correct nut to fit the stud part #007-112-00 which would be the #38N.

Rick, according to Blue Ox the space between the bolt holes at the end of the Demco Tow Bar Adapter for Blue Ox Base Plates #DM9523041 is 1.63" ( 1 5/8") so it'd be a quarter inch larger, and should work fine for you.

Hey Philip so while we don't carry the exact spring you are looking for it does match the specs of the #e59SR so this would be a great solution. It's correct length at 23-1/8 inches and is for a 3,500 lb trailer axle like you have as…