Search: B&w drop hitch   >  

The 4 mounting holes for Enclosed Cargo Trailer License Plate Holder #LP35BB are very small so something like an 1/8 inch self-tapping screw should be what you need. If you already have some screws that are larger there is no harm in using the…

The bases for the 2 inch ball and 2-5/16 inch ball are the same for the Trailer Valet XL models, so you can swap out one diameter ball for the other. My contact at Trailer Valet says it will just take a good wrench to remove the 2 inch ball and…

The yellow wire of the 7-way harness part #H20044 that you referenced goes to the center pin of the 7-way which is an aux circuit that is typically used for reverse lights if present on the trailer. Normally the red wire on a 7-way (RV standard…

The Trailer License Plate Holder with LED Light #328-003-71BE uses non-submersible lights. Although this would not work well on your boat trailer, I have a different solution. I recommend using the LED Trailer License Plate Light #LPL82CBB. This…

The correct hardware to mount the Optronics License Plate Holder #LP35BB mostly depends on the type and thickness of the surface you want to mount it on. This plate holder has 4 pre-drilled holes for mounting and these are hidden by the plate once it…

Yes, you can use a 2 5/16" hitch ball, like the 2-5/16" Hitch Ball - 1-1/4" Diameter x 2-3/4" Long Shank - Chrome - 20,000 lbs #63840, on a trailer that has a 2 5/8" Coupler. You will just want to make sure that you get the…

That part number is not active anymore but it basically is just a 7-way with wiring like our part #H20044. This is a trailer side 7-way with a 6 foot long wiring harness attached to it.

For a 4-way trailer wiring harness for your 2017 Lexus RX350 that has the tow package you would want the part #56083 which is a confirmed fit. This harness does not have a converter box built into it and it just plugs right into a port you have at…

The Bargman 7-Way, RV-Style Connector #WG54006-043 referenced in your question uses the standard RV-style pin locations for its 7-Way connector. I have attached a diagram of these locations and their functions for you to check out. Wire colors will…

To determine which brake assemblies would be needed, you will need to measure your existing brake drums as shown in the provided photo. Since your trailer has a 14,000 lb capacity, you most likely have tandem 7,000 lb axles, which typically use a…

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

The B and W Tow and Stow for GM trucks that have the Multi Pro tailgate that has the most drop is the part #BWTS20066BMP which has 7 inches of drop and fits the 2.5 inch hitch. This would be the correct hitch size for your 2020 GMC Sierra 3500 as…