Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
To wire a 7-Way trailer connector at the rear of your 1994 Chevy pickup, you will need to start with a working 4-way connector, item #118315, if your truck is not already equipped with one. You would then use the 4 Pole to 7 Pole and 4 Pole…
view full answer...You can refer to the linked help article for details on the wiring under the hood of your 2003 Silverado that you need to connect for trailer brake controller installation. There are both red and blue wires, as you noted. These are normally located…
view full answer...In order to convert the 4-way on a 2022 Ford Maverick to a 7-way you'll need the 4 to 7-Way with 4-Way part #ETBC7L. This kit comes with the actual adapter and everything else you need such as wires, connectors, and circuit breaker. It also…
view full answer...Your existing Lippert 3,500 pound axle has an 86-1/2" hub face length and a 68-1/2" spring center length. While I do have a great option for replacement, we don't offer any standard straight beam units that match these dimensions. If…
view full answer...Great question! Proposing, or the back and forth movement, typically occurs when the trailer isn't loaded properly so you have either too much or too little tongue weight, or your trailer simply isn't level. This doesn't allow the trailer…
view full answer...Porpoising (bouncing like you described) and sway are both commonly caused by the same thing when towing and that is not enough tongue weight for the trailer relative to the total amount of weight the trailer weighs. You need the tongue weight to be…
view full answer...The Correct Track Trailer Alignment and Lift Kit - Tandem Axle #RR23QX will work to raise your trailer by 2-1/4 inches which will help with your clearance issues. As for the equalizer, to determine the correct replacement, you need to measure yours…
view full answer...I wasn't able to find any specific information on your 2015 AML Auto Hauler open trailer with tandem 5,200 lbs axles current suspensions. There isn't a database I can look at and tell you exactly what part number you will need. The Lippert…
view full answer...You would need to go by the dimensions of the Global Link Vise Lock #295-000024 to determine fit. The 2 mounting holes at the top are spaced 2-13/16 inches apart on center. And from the center of those holes to the center of the bottom hole is…
view full answer...The 7-way on your Toyota Tundra can be replaced with the Replacement Multi-Plug 7-Way and 4 Pole Trailer Connector #20137 to give you both the 7-way and 4-way functions. Your other option is to add a 7-way to the bed of your truck for your camper…
view full answer...There could be corrosion or dirt inside your 7-way that needs to be cleaned out before all of the circuits of the 7-way will activate. That's the most common reason circuits on a 7-way won't function properly. You can test this easily by…
view full answer...The trailer hitch I recommend for your 2010 Forester is the Draw-Tite Hitch Receiver, part #75650. This is a Class lll hitch and it has a 2 inch receiver opening. I researched the owner's manual and found that the maximum tongue weight allowed…
view full answer...Related Searches
Filter Your Search
Contact and Help