Result: 6 lug hub

Hello Sherrie. No, I am sorry but we do not carry that inverter. We do however have the Go Power Industrial Pure Sine Wave Inverter - GFCI - 400 Watt - 12V #34282692 which would work just as great. This 400 watt inverter offers pure sine wave output…

Hey Scott! Yes, the ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat item #277-000164 will turn on at temps lower than 45 degrees. It has been tested and will work with temperatures as low as -32 degrees. I have linked an installation…

Thanks for the information on your trailer. For your axle with brakes I recommend the Trailer Hub and Drum Assembly - 5,200-lb and 6,000-lb E-Z Lube Axles - 12" - 6 on 5-1/2 #AKHD-655-6-EZ-K if you have the spindles with the integrated grease…

The 3,500 lb capacity Trailer Axle w/ Electric Brakes #e45SR has spring centers that are 80 inches apart so it wouldn't work as-is with 81 inch spring centers. You could use it but you'd have have its spring centers removed and new Spring…

It is certainly possible for any axle to wear out enough over time to need replacing. Since the suspension is built into a torsion axle if the suspension part was to wear out pretty much the only solution would be to replace the axle. If the…

I reached out to JR Products and the RV Holding Tank Heater #372HTH-A will turn off when the area reaches 39 degrees Fahrenheit. So it will only heat the tank when the temperature drops below 34 degrees and will shut off once the temperature reaches…

To figure out what size hub your are going to need for this axle we are going to need the wheel bearing numbers off the axle you are wanting to change the hub. The numbers can tell us size the spindle on the axle and tell us what the weight capacity…

The Kodiak Disc Brake Caliper 3,500 lbs to 6,000 lbs #KDBC225S and similar finishes will require the Kodiak Disc Brake Caliper Rebuild Kit for 3,500 lb to 6,000 lb Trailer Brakes #KDBC225KIT which will give you all the seals, bolts, bushings, and…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

If you remove the hub and wipe away the grease on the spindle you can check to see if it is damaged. Look for an scarring, gouges, discoloration, or scoring on the spindle. If the spindle is damaged then the bearings won't ride properly and can…

The C-Channel for Enclosed Trailer #362213-955 has an opening of 1.027". I have included an image below with all the dimensions for this item.

The Transcom #TCM 21344 TB cross references to the 10-10 seal we offer, part #RG06-090. The seal has a 2.125 inch ID and a 3.376 OD. It's compatible with a 25580 inner bearing.