Result: 4 way plug cover

Harbor Freight trailers do not typically use standard hubs or spindles. In most of the situations that we have encountered, we do not carry a hub that uses the same bearings and seal that Harbor Freight uses. The best way to determine if we have a…

Though we do have the replacement bearings, races, and seals available for your Hadco 3109 hub (which I have listed below), the combination used will not have an equivalent replacement hub available, unfortunately. Replacement Trailer Hub Bearing…

So the bearings that were included with the trailer kit are too small to fit on the spindle? It sounds like they gave you the wrong hubs or bearings and you would need to take it all back or contact the manufacturer for the correct ones. In order to…

The Dexter Trailer Idler Axle Beam with EZ-Lube Spindles - 60" Long - 2,200 lbs #T20BTR-EZ-6048 will fit any trailer with spring seats 48 inches on center. If you Harbor Freight trailer has leaf springs that are 48 inches on center then you will…

The Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers #3034-P is compatible with the Tekonsha Prodigy P3 Trailer Brake Controller #90195 and the 2018 Ford E-series Cutaway which is what your motorhome would have been built on. This is…

As long as the flat tow wiring is wired in before the 4-Way #C93ZV and you connect the power for the converter directly to the battery it will work. I have seen several use Magnetic Lights #TL21RK which they will wire in on the main harness to have…

Your tires should be 18.5 x 8.5 - 8 tires, which means they are on 8" wheels. If so, that is the same as a 216/60-8 tire which measures 18.2" in diameter. The tire covers I recommend for you are the Adco Tyre Gard #290-3975, which fit…

The Hopkins towed vehicle trailer wiring kit part #HM56200 that you referenced is designed to install by plugging inline with the vehicle's taillight connectors. That shouldn't be a problem for a trailer lighting kit that installs the same…

Yes, you are correct. The Hopkins Custom Tail Light Wiring Kit for Towed Vehicles #HM56200 and the T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #118416 will just plug into one another.

Roadmaster has a great solution for this. So what you end up doing is wiring the outlet kit part #RM-9332 directly to the vehicle battery so that you can power the Blue Ox Patriot part #BLU37TR directly from the battery while it is disconnected from…

Does your RV have a factory installed 7-way at the rear of it? If so, the harness you are looking for to plug in the part #3034-P will be behind that panel that's on the right side of the dash. If you check out the picture I attached you will see…

The coin tray on the dash of your 2017 Ford E-450 can be simply pried out with a slot screwdriver. You can gently insert the screwdriver between the tray and the dash piece that surrounds it. You will then pry the tray out. Just be sure to apply…