Result: 3802346

Hello David. All of the 2-1/4" or 2-1/2" long 9/16" wheel studs we offer have a knurl diameter of .68, such at the Kodiak Wheel Bolt #K916WB25. We do not have anything with a knurl size of .60 or .62. We do have some 1/2" studs…

Hello Pat. The Replacement Trailer Hub Wheel Stud #RG03-080 has a .545" knurl diameter. The distance from the cap to the threads is 1-3/16".

I checked with Dexter and they indicate that for hub 008-386-80: "Available for service parts only." Meaning the actual hub assembly is not available but parts for it are such as the 35mm cartridge bearing #31-72-3. There isn't a way to…

We have the perfect idler hub set up for you! The Dexter Trailer Idler Hub Assembly for 12,000-lb Axles #8-214-8UC1 has an inner bearing #3984 and an outer bearing #28682. The idler hub has a bolt pattern of 8 on 6-1/2 inches. The hub has an oil bath…

Thank you for the pictures Matt. I do see you have the backing plate for the brakes so you are most likely going to have #84 spindle since your axle has a 3,000lb capacity. You can verify this by removing one of your hubs and measuring the landings…

I do have an option for you but Atwood was bought out and their replacement parts are no longer available, including the repair kit you would need. The best option is to replace that A-frame coupler with a new one that attaches to a 2 inch hitch…

When it comes to installing a trailer hitch on your 2000 MCI 40 foot Intercity Bus we do not have a custom hitch that would fit but you can weld on The Curt Class 5 Universal Weld-on Hitch w/ Brackets - 2-1/2 inch Receiver - 44 inch Wide #C37CR. The…

Hi Dan, and I believe you are looking for a 7-way with the wires connected such as the 4 foot long Hopkins 7-Way #H20043, 8 foot long #H20046, or 11 foot long #HM20048. These have the plugs as well as wire leads that go to your junction box, though…

Although we don't have a kit that includes the bearings/seal all in one package, you can certainly obtain the parts separately. You'll need: #25580 inner bearing and its #25520 race #LM67048 outer bearing and its #LM67010 race #21325 Double…

In order to charge an on-board trailer battery you'd need to have a seven way connection on both the vehicle and trailer, this would contain the necessary circuits to pass a charge from the vehicle battery to the trailer battery. If you don't…

To completely rewire your 20' trailer from start to finish I recommend using the following parts: 7-Way Connector and Cable - Hopkins Molded Cable 8' Long item #H20046 Junction Box - Trailer Wiring Junction Box - 7 Color Coded Terminals item…