Result: 3500 lbs Trailer Leaf Springs

Based on the information I could find on your 2023 Jayco Jayfeather 30QB travel trailer it appears you are going to have 4,400lb axles. You are going to need to verify the diameter of your current axles as some manufacturers like Lippert use a…

Hello Lyn; I can definitely point you in the right direction of a new shackle kit and leaf springs for your 2019 Grand Design Imagine 2500RL. The 2-1/4" long shackles are pretty common and for that I recommend the MORryde Suspension Upgrade Kit…

From the information available to me, the Greystone Standard RV Microwave w/ Trim Kit, #324-000105 does not have the exact measurements as the Advent microwave, but they are very similar with a slight difference in height, less than and inch.…

The 2x2 inch square axle is likely 3,500 lbs or less capacity. I would need more spindle dimensions or bearing numbers to assist. If you pull a hub and measure at the spindle where the bearings and seal ride using the digital caliper like #PTW80157 I…

Hey Mike, it would be really odd if your other axle used a different bearing kit so I would feel very confident that if the one axle took the part #TMK52VR the other would too.

I do have an option for you, but we do not carry the Dexter 072-027-00 you mentioned. However we do have the etrailer Double-Eye Spring for 7,000-lb Trailer Axles - 24-7/8" Long #e64SR which will be 3/8" shorter but that is still close…

Though I may have an option for you, I was also unable to find any info on the T-23972 seal you currently have. With that being said, the Grease Seal - Double Lip - ID 1.719" / OD 2.565" - for 3,500-lb Axles - Qty 2 #RG06-050, or #58846 as…

I can help you figure out how to determine the best option for a wet bolt/shackle upgrade kit, though in order to determine the correct one you will need to take a quick measurement of the shackle straps on your Jayco Jay Flight. The reason for that…

Since your 3,500 lb trailer axle leaf springs are flat and measure 26-1/8 inches the correct replacement would be the #e54SR which measures 25-1/8 inches.

MORryde does not make the Premium Rubber Suspension Kit item #MR97ZR for trailer's that have a 42" wheelbase. They do make the MORryde 14-3/4" Shock Absorbing Equalizers item #MR34AR. These are specifically designed for 42"…

Jeff, I believe that is an older TDE hub which would mean that the Trailer Idler Hub Assembly for 3,500-lb Axles #AKIHUB-545-35-K is the correct replacement.

The Roadmaster Comfort Ride Shock Absorbers for Tandem Axle Trailers #RM-2450 can be used with both underslung and overslung axles. As per the instructions you will need to bolt up the extension plates in the correct orientation for your axle(See…