Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
I looked up your Dexter 8-222 Hub and was able to find the inner and outer bearing numbers as well as the grease seal used. It looks like this particular hub was designed for mobile homes and these, for the most part, have more unique bearings and…
view full answer...We had a customer who was able to replace his Dexter 8-155 hubs with the #8-201-5UC3-EZ that you referenced so they should work well for you. You can verify that this hub will work for you by pulling your current hub and making sure they have inner…
view full answer...Yes the Replacement Brass Connector #T4750300 for Titan Disc Brake Actuators will fit a Tie Down 660e disc brake actuator.
view full answer...To replace your AL-KO 568303 seal you will want the Oil Seal #91030. This seal has the same inner diameter of 2.750 inches and outer diameter of 3.779 inches. It is a confirmed fit for your #99 spindle that uses the AL-KO 568303 seal.
view full answer...To install your Reese Pod brake controller in your 2018 Ford Explorer will require the install harness part #3035-P which is a confirmed fit. If you check out the 9:55 mark of the install video I attached to this page you'll see where to find the…
view full answer...The process to install a 7-way and trailer brake controller on your 1997 Ford F-350 is not very involved. For a 7-way, you can use the Adapter 4-Pole to 7-Pole and 4-Pole part #37185 as long as you already have a 4-way like the T-One Vehicle Wiring…
view full answer...Hi John, Yes, we do have everything you'll need to flat tow your 2024 Chevy Trax. Baseplate: Blue Ox Base Plate Kit #BLU24UR. Tow Bar: etrailer SD Non-Binding Tow Bar for Blue Ox Base Plates #e47ZR. This tow bar comes with safety cables included…
view full answer...The overload warning you are seeing indicates that the P3, #90195, detects an excessive current overload condition during operation. This means that there is most likely a short in the brake output wire. The P3 has diagnostic troubleshooting…
view full answer...For a receiver hitch that will fit your 2002 Chevrolet Silverado 1500, I recommend going with the Draw-Tite Ultra Frame Trailer Hitch Receiver #41932. This has a max towing capacity of 12,000lbs and max tongue weight of 1,200lbs; or 14,000lbs and…
view full answer...It's pretty simple. A 4-bolt rail uses four 5/8 inch bolts ran through the floor of the truck bed into the frame brackets. The bolts run down through the center of the raised part of the rail, as shown in the photo I provided. A 10-bolt rail uses…
view full answer...For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…
view full answer...A 155/12 tire will be about 6.1 inches wide. The closest match is a 145/12 at 5.7 inches wide. I have included a link to all of the tires and tire/wheel combos we have in this size. A 155 isn't a trailer tire size (unless it has an ST in front of…
view full answer...Related Searches