Search: 2 5/16 coupler   >  

I am sorry but the industry standard for channel couplers is 2" spacing (center to center) with 5/8" holes. We do not have any options for a 1-1/2" spacing. My only solution is to recommend welding on a new channel with standard…

There is not a repair kit for the thumb latch of the A-Frame Trailer Coupler - Underslung - Thumb Latch - Black - 2-5/16" Ball #CA-5335-B. While I wish we had an option for you, if yours has busted you will need to replace the entire coupler.

The only difference between 7-Way Utility and 7-Way RV is the color of the wires. The pin outs are the exact same so either would work just fine with the other. If you check out the picture I attached you'll see that the functions are all the…

No, it will not sorry. The Demco Channel Tongue Trailer Coupler item #DM16080-95 won't fit a trailer tongue that is wider than 3". Additionally, I do not have a coupler like this that will fit a channel wider then 3". You may be able to…

We do have a very similar replacement coupler that is rated for 21,000 GVWR, and it is the Titan Bolt-On Coupler #T4855300. The angle that your photo was taken I can not tell if it is a 2 or 3 hole adjustable coupler, but this Titan part is a 3 hole…

Thank you for the image. It appears you will need either the Demco Channel Tongue Trailer Coupler #DM13203-95 or #DM16080-95. Both of these couplers have a zinc coating for increased corrosion resistance and fit on a standard 3" wide channel…

The American CS6000XL that you referenced is no longer available and there isn't a direct replacement for it but the closest solution as a replacement would be the Progressive Dynamics RV Control Center part #PD4560K18LS8 which as the same…

We have heard of this issue before on the Lippert Ground Control systems #LC358590. Here is the recommended procedure for clearing the error code: Extend all jacks at least 6 inches. Then press and hold the RETRACT button until the jacks begin…

You can convert surge brakes to an electric over hydraulic braking system. To do this, you will need an electric over hydraulic actuator and a brake controller. For an electric over hydraulic actuator, I recommend looking at the Carlisle HydraStar…

To allow for full articulation so you don't have to worry about the tires bottoming out int he wheel wells, I'd recommend going with a 15° down torsion axle. If the original axle was a 0°, this would raise the trailer up a bit. A…

From what we have found, the Nissan factory brake controller harness has the following color/functions: Nissan Red to brake controller black for 12-volt power Nissan Red with green tracer to controller red for input from stoplight Nissan black to…

I went out into our warehouse and measured the inner and outer diameter of the mounting bracket that is on the Bulldog Round, Pipe-Mount Swivel Jack #BD178101 and found that the outer diameter measures 2 inches and the inner diameter measures 1-1/2…