Result: 1779

It sounds like you have the older hub 22834 that is no longer in production that takes the outer bearing of part #1779 and inner bearing of part #2788. I was not able to find any other bearings that measure .093" inner diameter besides 1779 or…

I did some research and found that the 2,600 lb Hub, #22834, takes the #1779 outer bearing and #2788 inner bearing and would use the #29031 grease seal. This hub has a 6 bolt on 5-1/2 inch bolt pattern. This sounds like the hub you have, and…

You will need to measure the diameter of the spindles where the seal and bearings ride. Check out the picture I attached that shows where this is. You will need an exact measurement so either a digital or dial caliper will be needed. To pick out the…

The Titan 6 on 5-1/2 Slip-On Hydraulic Brake Drum Assembly - Cast Iron - 12" #T4404700 is a standard size drum 12 x 2 inches to fit a 12 inch brake assembly. I reached out to the manufacturer and from the mounting surface to the rear of the drum…

There is no way to know for sure with a measurement of 15/16 of an inch what the correct bearing is. The only way to know the correct bearing is to use a digital caliper and measure your spindle to the thousandths of an inch where the bearing rides.…

Spring Hanger location dimensions are normally figured by the manufacturer and provided with the spring hanger kit, that includes all of the parts for installing the springs on the trailer frame. I have provided a chart that shows the spring hanger…

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

You can verify that the 10-19 grease seal included in Bearing Kit #BK2-100 is the correct one for your spindles by taking two measurements. First you want to measure the rear hub bore where the seal is inserted. The seal's outer diameter needs to…

Yes the pipe diameters of the #BDPG9810-00 and the #TJDP-7000S-B are the same. Both of them have a 2 inch inner diameter and a 2-1/2 inch outer diameter.

If your rod is 1-1/4" diameter, then it sounds like you have a 12K Bulldog Trailer Jack for which the Replacement Screw and Nut Kit part #BD500217 at 17" long x 1-1/4" diameter most closely resembles the Replacement Rod and Nut Kit…

At 8 or 9 inches you're good but not at 23 inches per side. If this is a build you are doing then the frame width will have to be greater. Otherwise you will run into suspension, tire wear, and running gear problems. I checked with Dexter Axle…

We currently have not had a Ford F-150 with the power outlet in the bed to test fit a bed mounted 7-Way #C57008. I see no reason you will not be able to still install the 7-way as there is a large gap which can be seen in the installation video which…