Search: 15302   >   Trailer Hitch   >  

Curt Trailer Hitch Receiver #C15703 hangs pretty low on a 2005 Chevy Silverado 2500. From the bottom of the bumper to the top of the hitch receiver it is approximately 4 inches. I have included a picture showing the gap. A similar hitch, #C15302,…

The Curt Trailer Hitch Receiver part #C15400 and the Curt Trailer Hitch Receiver part #C15800 are the exact same trailer hitch save for one has a 2" receiver tube opening and the other a 2-1/2" receiver tube opening. The dimensional drawing…

It is, I went and measured the distance from the mounting flanges of a Curt Hitch part #C15703 to the cross tube that we have in stock and found that it measures right at 6 inches. I attached an install video for you to check out as well.

The #14108 trailer hitch is not a fit for your Silverado but we do offer a hitch that will work for you. I recommend the Draw-Tite Ultra Frame Trailer Hitch Receiver, part #41944. This is a Class V hitch and it has a 2 inch receiver opening. This is…

I had our warehouse measure the Curt Trailer Hitch Receiver #C15703 you were looking at, and has an overall width of 40-5/8", overall length of 29". The distance between the vertical mounting holes is 14-1/2" center to center, and the…

We haven't had the chance to install the Curt Class V Trailer Hitch Receiver #C15703 on the 2008 Chevy Silverado 2500 so I don't have exactly how far beneath the bumper the receiver will sit, however I did go out to our warehouse to take a…

The Draw-Tite #DT45519 is designed to be used on the 8 foot bed models of the GMC Sierra and will not fit the short bed models. That being said, we do have Class V hitches with a 2 1/2 inch receiver options available for your short bed truck. The…

I went to the warehouse and measured the Curt Trailer Hitch Receiver, part #C15703. I have attached a photo of the trailer hitch and have noted the dimensions you can check out. This is a Class V trailer hitch and it has a 2-1/2 inch receiver…

For a 2002 GMC Sierra 2500 HD, you'd want to use the Curt Class V hitch, part #C15703. I checked with Curt, and found that the drop of this hitch (measurement from the mounting flange to the top of the crossbar) is 5.13 inches, as shown in the…

Curt does not have that measurement available, but you can determine this for yourself by taking some measurements from the underside of your truck. Using the diagram I edited for you, locate the weldnut that would serve as the rear-most attachment…

The Hardwired Power Watchdog Surge Protector with Bluetooth and Emergency Shut Down - 50 Amp Item #HU27FR is compatible with generator use. One thing you will have to note is that some generators have a ‘floating neutral’. This might cause the Power…

I have attached a photo for you below which shows how both a vehicle side and trailer side trailer connector is typically wired. I say typically because this is not always exact and so long as the trailer and vehicle side both match it will not…