Thanks for the pictures! Since your UFP Gold Series oil bath hubs have a 1.98" outer bore then yes, the Kodiak XL ProLube Oil Bath Hub Body and Cap item #xlprolube1980 would work for your boat trailer. The directions say to fill to…
According to Dexter, this is a 3,750 lb torsion axle with a 90.3" hub face measurement. More than likely your axle uses #L68149 and #L44649 bearings with a #168255TB grease seal. You will need to verify this information since Dexter did not have…
My first thought would be blown fuses, so I would be sure to double check all fuses and relays related to the tow package. This information will be listed in your owner's manual. Check to ensure you are getting power at the trailer connector on…
If you have a vehicle specific wiring harness for a brake controller then that would indicate that you have a factory tow package and subsequently would already have a 7-way at the back of your vehicle. The universal 7-way connector #ETBC7 is meant…
The Quick Disconnect Wiring Harness you mention, part #DL24151 is designed to plug directly into the winch, as shown in the photo I produced for you. According to the instructions, the wiring harness is meant to be unplugged and stowed in the tow…
You can use the Pollak 7-Way to 12 Volt Power Outlet Adapter #PK11896 but you will need to switch out the connector on your air compressor. You will need to find a male cigarette plug that is rated the same or higher. If you decide to run a line from…
From what I have found, the 023-447-00 brake assembly is the same 15,000 lb right hand assembly used in the Dexter Electric Brake Kit #3-446-447. We have one 15k drum available, the Dexter Trailer Brake Drum for 12,000-lb and 15,000-lb Axles -…
On your 2000 Chevrolet Silverado the left and right brake signal wire is separate from your turn signal wires. To connect this style of vehicle wiring to a trailer wiring connector you will need to use a 3-wire to 2-wire connector like the Hopkins…
It most likely would be wide enough. A 205/75-14 tire can fit on a 5, 5-1/2, 6 or a 6-1/2 inch wide rim. A 215/75-14 tire fits on a 5-1/2, 6, 6-1/2 or a 7 inch rim. It's nearly impossible to determine the correct width of a given rim unless the…
If you have a Lippert 3,500 lb Square Torsion Axle then the correct lift kit is the Axle Riser Kit part #LC382741. That said, none of the Dexter Torflex Lift Kits like part #K71-725-02 will work.
Thank you for the photo of the axle sticker; that's always helpful in helping us identify what you've got. That serial number is for a Torflex #10 axle, so the correct lift kit is the #K71-707-01 for a single axle or the #K71-707-02 if…
Filter Results
