Result: 13333

Hello William. We do have the Replacement CAN Bus Data Cable for Lippert Ground Control or OneControl Leveling System #LC45ED. This cable is 20' long and will replace the cable that connects to your ground control leveling system. This is…

Dutton Lainson trailer winches like the #DL14125 have bolt patterns that are designed to fit the standard bolt pattern the winch mount on your boat trailer would have so this will work for you. Most of the holes are slotted on the plate of this winch…

It's pretty simple. A 4-bolt rail uses four 5/8 inch bolts ran through the floor of the truck bed into the frame brackets. The bolts run down through the center of the raised part of the rail, as shown in the photo I provided. A 10-bolt rail uses…

Since fifth wheel rails attach and are supported by the frame rails and not the truck bed it is possible to install a fifth wheel rail kit in a truck with a Carbon Pro bed like your 2021 GMC Sierra 1500 that has a 5-3/4 foot bed. Since your truck bed…

As you only have the passenger side not working it sounds like their is either damage to the wiring or the step motor. First you will want to use a Test Light #PTW2993 to check for power on the harness of the Aries ActionTrac Motorized Running Boards…

The first thing I would do is check your power switch on your #AA3047902. If the switch was turned off that would explain why they aren't functioning. After that, go ahead and double check the sensors and make sure they are plugged in with a good…

The best option I have for you to add a trailer hitch to your shuttle bus is with the Draw-Tite Ultra Frame Service Body Trailer Hitch Receiver part #41990-16 which has the Class V rating that you are after. In regards to installation, this will be…

We do actually have a video of the Curt #C67JR being installed on a 2022 Subaru Outback Wilderness! I have it linked below. You will not need to remove the bumper cover to get the #C67JR installed, but you will have to lower the exhaust and pop those…

Hey Steve! Yes, the Replacement Solenoid for Superwinch LP Series Winches #SW90-12877 is what you need for your LP8500 winch.

When you are hardwiring a trailer brake controller like the Prodigy P2 #90885 the red wire connection that provides the triggering signal to the controller should be made to the wire on the COLD SIDE of the brake light switch circuit. This is the…

I'm guessing it is approximately 3-3/8" across if you measured it. Unfortunately there are no options that will slide in because it won't line up correctly, and everything is designed to fit a 3" tongue so it is too wide to mount an…

I recommend replacing the hinges on your 1990 Sooner SH slant trailer with the T-Strap Hinge #PLR3408-SS. These hinges are stainless steel for increased life and are stronger than the aluminum hinges you currently use. They are also have a larger…