Search: 10 19 seal   >  

You are correct that both the Curt #C94WR and Draw-Tite #DT22MR you were looking at for your 2022 Hyundai Tuscon are very similar. Both hitches share the same 525lb tongue weight and 3,500lb trailer weight ratings, both share the same hidden…

We have a similar etrailer hitch that fits your 2021 Ram 1500 Classic with the part #e98852, but the #e28ZR fits the non-Classic models.

You are going to want either our Bearing Kit #BK2-100 or the Timken Kit #TMK52VR. Both of these kits will give you the inner/outer bearings and races along with a grease seal and cotter pin/D-washer for one hub. You always want to replace the race…

We have just what you are looking for. I called my contact at TDE and asked about the hub you have on your boat trailer. They told me that it was a 5-stud idler hub for a 3,500-lb axle. That means you need the part #AKIHUB-545-35-K. This is a fit for…

The Trailer Idler Hub Assembly part #AKIHUB-545-35-G-K or part #AKIHUB-545-35-G-EZ-K for easy grease will be a direct replacement for the TDE 46210. That said, you may also need the Double Lip Seal part #168255TB since that hub can use two different…

There typically aren't any part numbers stamped onto the trailer spindle that can be used for identification. There are however numbers stamped onto the hub most times which can be used for identification. The TDE46210 tells me you have a 3,500…

The etrailer.com Self-Adjusting Brakes #AKEBRK-35-SA will replace both brakes on an axle, but do not come with the hubs. That being said, if the hubs are in good condition, they will not need to be replaced. When you remove the hub, you will need to…

Since you have a 3,500 lb axle most likely the diameter of the threaded portion of the spindle is 1 inch. You will need to verify that. And since the spindle has a hole in it for a cotter pin you would need a castle nut. For that I would recommend…

The nut on the spindle should be tightened until snug, with no side-to-side play in the hub and then backed off slightly, about maybe a 1/8 of a turn. If the spindle uses a castle nut and cotter pin or tang nut, tighten the nut finger tight until it…

We currently have not had a Ford F-150 with the power outlet in the bed to test fit a bed mounted 7-Way #C57008. I see no reason you will not be able to still install the 7-way as there is a large gap which can be seen in the installation video which…

On each individual electric brake magnet the amperage draw would be 3.0 to 3.2 max amps at 12 to 13 volts on 7-inch brake magnets and 3.2 to 4.0 max amps at 12 to 13 volts on 10 and 12-inch brake magnets. The max amperage draw for the brake magnets…

The spring hanger placement is going to be determined by your axle spacing. For example, if your axles are spaced 33 inches apart, as shown in the attached diagram, a 7K axle slipper spring, like #e74SR, requires a distance of 28-1/2 inches between…