1972 Radiator Fan

Hey Trent, from what I found your 1995 Jeep Grand Cherokee uses an 18 inch diameter clutch fan like the part #D17118. The part number you referenced is 17 inches so it wouldn't work but I would recommend measuring to verify this.

Hey Bob, Landing gear components aren't all interchangeable between brands so I'd need to know the exact model to find replacement parts for your current system. If you're just wanting to replace the landing gear as a whole then I'll…

Hey Charles, yes we do have the Curt trailer wiring harness part #C98RV that is a confirmed fit for your 2024 Hyundai Santa Fe.

Hey John, the Air Lift kit part #AL57230 that fits your 2007 Dodge Ram 1500 is compatible with in-bed hitches but not mega cab models. The part #AL57295 is a fit for the mega cab models and fits with in-bed hitches. The part #AL88295 fits mega cab…

Hello Jeremy, thanks for reaching out. The Air Lift Air Helper Spring Cradles #AL59DQ will only work with the Air Lift brand bellows-style air bags. They will not work with the Firestone air bags.

Hello Ernest, We are just here to help with any questions people have, regardless of if they bought the parts through us or not. Unfortunately, we no longer carry the knob for the V2, they have upgraded to the V3 model and we have sold out of all our…

Nissan refers to their cab style that is most commonly considered to be "extended cab" as a King cab. The Curt hitch part #13831 that you referenced is a fit for the King Cab 2003 Nissan Frontiers so it would work well for you. I also…

Using Loctite when installing a trailer hitch is not required but it can certainly be used to create an even stronger bond. Blue Loctite like the Blue Stick #LT37643 is plenty sufficient for this application. As long as the hardware for your hitch is…

We have a dual fan setup that is VERY close to what you are looking for but is 1 inch deeper than what you mentioned with the part #D16833. This is rated for 3,750 CFM, is 24 inches wide, 17 inches tall, and 4-1/2 inches deep. If the depth is an…

Yes, there is a bolt that goes all the way through that holds the Timbren Rear Suspension Enhancement System item #TGMRG25C in place. I have linked the instructions and an installation video below so you can see the steps involved and all the tools…

Hi Bob! The Timbren #TGMRG25C you ordered will have 6,000 pounds of load assist and will be the highest rated option available for your 2003 Tahoe. This will definitely solve your sagging issue, especially if you are close to or at the maximum load…

Unfortunately the Lippert electric jack #LC285318 has had this issue and they haven't found a solution yet but say they are working on it. Currently, the only thing you can do is replace the jack. The issue with both the motor and the nut is the…