Hub and Spindle Recommendation for the Kenda 215/60-8 Bias Tire with 8" Galvanized Wheel # AM3H325

Question:

Im looking to assemble tongue mounted wheel for launching my zodiac off the beach into the surf like the 3rd wheel seen here: using the Kenda 215/60-8 Bias Trailer Tire with 8inch Galvanized Wheel - 5 on 4-1/2 - Load Range D is there a stub axle and hub assembly i can use to fabricate this? I appreciate your help..

0

Expert Reply:

For a hub to match the bolt pattern of the # AM3H325 that you referenced you will want an idler hub that has a matching bolt pattern, 5 on 4-1/2 inches. For a hub I would recommend the part # 84545UC1-EZ, and then for a spindle part # R40484.

expert reply by:
0
Jameson C

Products Referenced in This Question



Product Page this Question was Asked From


Follow up Questions

Similar Expert Q&A Pages

See More Q&A Expert Answers >>