What is Diameter of Boat Trailer Roller Retainer Ring and Will It Fit a 1 Inch Shaft  

Basically, you put the open end around the shaft on each end of the roller then use some pliers to clamp it closed so it is tight to the shaft. This allows the roller to roll but stay in position. I made a video showing what this would look like for…

If the 3/4-inch shaft where you intend to install Yates Ribbed Wobble Roller #YR343R-6P has a hole for a cotter pin, then yes, you can secure the wheel that way and I suggest placing a flat washer between the roller and the cotter pin to avoid any…

The way to install the new #YR343R-6P roller is pretty simple. You'd can use pliers or channel locks to remove the existing retainer ring and the old washer. Then remove the old roller. install the new roller part #YR343R-6P and washer part…

You need the Yates Ribbed Wobble Roller #YR500YW-8P. It matches your roller at 5" in diameter, 3" wide and uses a 1-1/2" long bushing to fit on a 1" shaft. The Washer For 1" Spindle #SW1000 are sold individually so be sure to…

Yes, as long as the inner bushing on your two piece roller installs on a 3/4 inch shaft or bolt then the Ribbed Rocker Roller, #DL21564, should work great on your 1096 E-Zee loader trailer. The width of the bushing that is pressed into this roller is…

There are only a few rollers that we carry that list specific trailers that they will fit. For everything else, you will need to go by the dimensions of the roller to determine if it/they will fit your trailer. I have included a link to the wobble…

Thank you for the photo and your rollers are definitely worn, and I do recommend replacing them. In order to find the correct wobble rollers, what you'll need to do is measure your current rollers, both the diameter and the width, as well as the…

I went out to the warehouse and pulled Yates boat roller #YR500YW-6P. The inside width where the shaft goes is 1-1/2 inches. I have included a link to a video review of this roller for you. Some related items you may also need are the retainer ring,…

You will want the Yates #YR530R-8P in heavy duty rubber. This wobble roller has a 5 inch diameter and is 3 inches wide. It takes a 1 inch diameter shaft. Bushing length is 1-1/2 inches. Clips like part #CE10981 are crimped on the ends of the shaft to…

The Yates Ribbed Wobble Roller, #YR500YW-8PEZ, is exactly what you need for your 1999 EZ Loader boat trailer. The bushings are included with this roller. For a hog ring, we offer part #CE10981 and you can use part #SW1000 for a washer. At this time,…

Sounds like you are looking for a way to secure the #CE10981 to the shaft for the installation of the part #YR343R-6P. A decent set of pliers like the part #PTW88003 would do the trick. Or a set of channel locks.

Boat trailer wobble rollers like #YR500YW-7P and not trailer-specific or brand-specific so if their dimensions match up you'll be fine using them as replacements. The key things to note are the size of the shaft hole in the roller, which is about…