Do Bronze Bushings for Trailer Suspension Require Reaming When Installing Shackle Bolt  

Thanks for reaching out about the Correct Track Trailer Alignment and Lift Kit #RR23QX, Mike! The instructions only mention adjusting the front axle before the rear axle, but I agree with you - the middle hanger that holds the equalizer will need to…

I have an option for you, but unfortunately we do not sell a kit with just the wet bolts and bushings for the Lippert Road Armor on your 2019 Keystone Montana High Country 375FL. I recommend the Bronze Bushing #D014-077-00 which is 9/16" I.D.…

Thanks for the pictures! Since your 2022 Grand Design Reflection 303RLS came with the CRE3000 equalizers you will need three of the MORryde X-Factor Crossmember item #MR33WR. It looks like you have the standard 3" wide frame hanger so all of the…

We do not have any equalizers with the dimensions you mentioned. From the looks of the photo you sent it appears the hole may be elongated and you may be able to use an equalizer that has all of the holes at 9/16-inch like part #TREQ356, or with a…

I have a replacement axle option for you, but based on the information I was able to find on your AL-KO 4400lb Axle #402268 it uses an older style of braking assembly that was discontinued when AL-KO was bought out by Dexter. If the brakes on your…

We have lift kits for trailer that easily add 2 inches to the height of the trailer. For that you'd want the part #RR23QX and you'd be set. I attached a picture that shows how it installs to give you an idea. This would be the easiest…

I definitely see what you're saying about the spacer, found as part #LC34UD, from the 2nd gen Correct Track LC407131. With that being said, the Correct Track Trailer Alignment and Lift Kit #RR23QX has been safety tested and works just fine…

The bronze bushings and wet bolts are a great option but they still do require maintenance especially under the conditions you referenced. There really isn't any new information in comparing it is basically the difference between maintenance…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…