Brake Controller Wiring Kit For Vehicle With 7 Way Already Installed

Question

Question:

You offer part no. ETBC7 for those that dont have a 7 way already installed. Do you offer a similar kit for someone that does have the 7 way installed, but needs the rest of the kit?

asked by: George W

0

Expert Reply:

We do offer the wiring kit # 5506 which will includes the wire, circuit breakers and connectors that come in the # ETBC7 kit. You can get a few feet of wire loom # 459075-1 and some zip ties. Since your vehicle already has the 7 way installed, that will be all you need.

expert reply by: Jesse M

0

Answer 1

I was able to find our video installing the Redarc #RED24FR on a 2020 Subaru Outback. I have linked the video below.

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

The best brake controller option to go with is one that activates the brakes proportionally instead of time delayed. A proportional brake controller will activate the trailer brakes at the same time and with the same intensity as the tow vehicle…

view full answer...

Answer 5

For your 2024 Nissan Frontier I recommend the Redarc Tow-Pro Liberty Brake Controller #RED24FR. I like the Liberty because it is simple, reliable, and looks great in any vehicle. The main unit installs behind the dash, so only the control knob will…

view full answer...

Answer 6

Hey Mark, thanks for reaching out, and good question. Both the Redarc #RED98CR and #RED82CR are correct for your 2022 Toyota 4Runner. The only difference is the #RED82CR comes with the universal mounting panel for the knob, while the #RED98CR does…

view full answer...

Answer 7

Yes, when installing the knob for the Redarc Tow-Pro Liberty Brake Controller item #RED24FR you will want to remove any extra material behind the insert. I am happy the video was able to help you out. I have linked a couple of pictures from the video…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Brake Controller Wiring Kit For Vehicle With 7 Way Already Installed

Product Page this Question was Asked From

Continue Researching