2012 Ford Explorer XLT Brake Controller Installation Instructions


Do you have instructions on how to install and Activator II to a 2012 Ford Explorer XLT without a tow package. I have already installed a hitch and the 4 way flat and have the 7 pin hopkins adapter. I just am not clear on how and where all the connections are made with the break controller and additional wires on the 7 pin. Can you please provide some assistance or directions....thank you!


Expert Reply:

Yes, it sounds like you have the Hopkins 7-Way Adapter part # 37185 and are looking for a way to install it in your 2012 Ford Explorer that you recently installed a 4-way into.

I attached an instructions link that will detail exactly what you will need to do and use to install the # 37185 in your vehicle and make your Draw-Tite Activator Trailer Brake Controller # 5100 fully functional.

I also attached a video that shows a similar installation for you to check out.

expert reply by:
Jameson C

Products Referenced in This Question

Product Page this Question was Asked From

Follow up Questions

What do you think?

* e-mail address format: [email protected]

I would like an email notification if someone replies to my comment

Similar Expert Q&A Pages

See More Q&A Expert Answers >>