Total Height Of The TorkLift GlowStep Revolution RV Steps When In The Stored Position

Question

Question:

When this step is in the stored or traveling position what is the height of the unit from the bottom to the top mount point? Thanks

asked by: Rick

0

Expert Reply:

The height of the TorkLift GlowStep Revolution Scissor Steps w/ Landing Gear # TLA8004 from the center of the mounting hole to feet of the steps (lowest point when open/closed) is roughly 14.5".

expert reply by: Kevin C

0

Torklift TLA8004 Closed Height
(click to enlarge)

Answer 1

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 4

The best air bag kit for your 2020 Ford F-250 Super Duty with a single rear wheel are the Firestone Ride-Rite Air Helper Springs because they are the strongest, most durable air bags on the market to provide you with optimal support for your…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 7

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 8

Hey Paul, we have great hitch solutions for the OEM pucks of your 2024 Ford F-350 short bed but whether or not you need a slider hitch is going to be based on the design of the trailer you plan to tow. Normally with a short bed truck you need a…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

To know if your 2017 Ford F-350 has an in-bed puck system installed you'll just need to look and see if you have four rounded attachment points (usually covered up when not in use, like in the attached picture). If you don't see these in your…

view full answer...

Answer 11

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Total Height Of The TorkLift GlowStep Revolution RV Steps When In The Stored Position

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching