What Does White Fade Color of Solera Smart Arm Power Awning Kit Mean

Question

Question:

What exactly does white fade mean?

asked by: Bob

0

Expert Reply:

White fade means that the awning fabric of the Solera Smart Arm 12V Power RV Awning # LC405523 is white closest to the RV wall and then fades to black as it gets further away from it.

expert reply by: Jameson C

0

Answer 1

If your fuse for your Solera Smart Arm 12V Power RV Awning #LC517517 is blowing as soon as you replace the old one, then there is a short circuit somewhere, or there is an unusually high amp draw. Since you're saying the fuse blows immediately,…

view full answer...

Answer 2

The black fade awning on the Solera Smart Arm 12V Power RV Awning - 20' Wide - Programmable - Black Fade Item #LC517517 is black on RV side and turns white as it goes towards the roller tube. Because of this the white will roll up inside of the…

view full answer...

Answer 3

The Solera Smart Arm 12V Power RV Awning - White Fade #LC405492 can also be purchased in Black Fade #LC517486 or the roller and fabric can be purchased separately in the following colors: Sand Fade w/ White Weatherstrip #LCV000334399. Silver Fade…

view full answer...

Answer 4

Welcome back! We do not sell the breakers you'll need for the Progressive Dynamics 4100 Series RV Converter item #PD4135K you purchased but I have listed below the ones Progressive Dynamics recommends. You can source them at your local hardware…

view full answer...

Answer 5

Since your Solera awning didn't come with the roller tube pre-built to accommodate a light strip, the best thing for your application is to go with the Vista Light LED Kit #LC25VR. This installs where the awning attaches and will actually work…

view full answer...

Answer 6

When choosing the slider you want to measure the outside front of box width including the flange. Then you need to select a slider that extends a minimum of 2-1/2 inches beyond each side of the box width. For example, the Black Solera Slider…

view full answer...

Answer 7

So long as it is a Solera roller like item #LC33FR or item #LCV000211518 it will. The roller tubes are brand specific so if your tube isn't a Solera it won't be compatible with the Replacement Support Arms for Solera 12V XL Power RV Awnings…

view full answer...

Answer 8

Hi Donald, For a 150" flange to flange measurement you'll need the Solera RV Slide-Out Awning #LCV000163299. This slide topper is designed to fit 146" - 151" flange to flange measurements. Going a size larger than this could…

view full answer...

Answer 9

Brien, it sounds like you did your research so kudos to you, but the awning you're looking at is not going to work with the wind sensor. You'd need to use the Solera Smart Arm 12V Power RV Awning #LC517517 instead. You're also going to…

view full answer...

Answer 10

The 14-foot dimension shown for the Solera 12V XL Power RV Awning #LCV000334942-362241 refers to the outside to outside spacing of the two included 78-inch-tall wall-mount vertical brackets that contain the awning support arms. The fabric canopy…

view full answer...

Answer 11

Yes, it is black. The black fade awning on the Solera Smart Arm item #LC517517 is black on RV side and turns white as it goes towards the roller tube. Once it is all rolled up though you'll see the black fabric. I get you don't want black but…

view full answer...

What Does White Fade Color of Solera Smart Arm Power Awning Kit Mean

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching