Which is Better Slightly Nose High or Nose Low Trailer
Question:
If the is 4.5, would you choose a ball mount that has a 5 inch or would a 4 inch . Which is safer, a slight tilt up of the trailer or a slight tilt down of the trailer My trailer is a tandem axle
asked by: Dan G
1
Helpful Expert Reply:
In most cases it's a bit safer to go on the slightly lower nose height setting instead of slightly higher since higher can sometimes cause sway. But if the vehicle is going to squat quite a bit from the weight of the trailer then the higher would work better which would be the case with the 4 inch drop ball mount part # 2753.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Draw-Tite Ball Mount for 2" Hitches - 2-3/4" Rise, 4" Drop - 9" Long - 7.5K
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- 1 Inch Ball Hole Diameter
- Steel Shank - Gloss Black
- Drop - 4 Inch
- Rise - 3 Inch
- Fits 2 Inch Hitch
- 7500 lbs GTW
- Class III
- Draw-Tite
more information >
Continue Researching
- Shop: Trailer Wiring
- Q&A: Can Ball Mounts Be Turned Upside Down To Increase Height
- Shop: Trailer Hitch
- Q&A: Availability Of A 1-1/4" Draw Bar And 1-7/8" Ball With 0" Of Rise
- Search Results: c59236
- Video: An In-Depth Look at the Curt Towing Starter Kit for 1-1/4" Hitches
- Article: Determining Trailer Tongue Weight
- Q&A: How Can I Tell if My 2013 Nissan Pathfinder Came With Factory Tow Package
- Shop: ZCI Circuit Protected Vehicle Wiring Harness w/ 4-Pole Flat Trailer Connector and Installation Kit
- Video: Hands-On with the Top Rail Trim for Enclosed Trailer
- Video: Let’s Check Out the J-Channel Trim for Enclosed Trailer
- Search Results: trim
- Shop: Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Shop: RV Roof Membrane
- Shop: T-One Vehicle Wiring Harness for Factory Tow Package - 7-Way Trailer Connector
- Shop: J-Channel Trim for Enclosed Trailer - 7/8" Tall x 1/4" Deep - Aluminum - Rounded
- Shop: Brake Controller
- Shop: Curt Towing Starter Kit for 1-1/4" Hitches - 2" Ball - 3/4" Rise - 3,500 lbs
- Shop: Curt Class I Ball Mount for Vertical Hitch Receiver
- Q&A: Are Fixed Cargo Carriers More Stable than Folding Carriers
- Search Results: hitch
- Search Results: 7 pin connector bracket
- Video: Fit Check: Testing 24x60 Curt Cargo Carrier for 2" Hitches on a 2017 Nissan Pathfinder
- Video: Compatible? Yes! The 24x60 Reese Cargo Carrier for 2" Hitches Fits a 2020 Nissan Pathfinder
- Search Results: 7 pin trailer connector tester
- Video: Mount: Curt T-Connector Vehicle Wiring Harness for Factory Tow Package on a 2021 Hyundai Palisade
- Video: Checking Out the Curt T-Connector Vehicle Wiring Harness for Factory Tow Package-C68JR
- Q&A: Is There a Plug-In 7-Way for a 2022 Hyundai Palisade
- Q&A: How Does Curt 7-Way Kit for 2021 Hyundai Palisade Connect to Brake Controller Wiring