Splicing New Taillight Converter Into T-1 Connector on 2013 Ford Escape

Products Featured in This Question

T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(312)

$74.15

Curt Powered Tail Light Converter w/ 4-Way Flat Trailer Connector and Install Kit

(125)

$162.40

Question:

I have a kit that I installed and it appears after testing that the module has gone bad. I dont need all the wires, just the module, I was wondering if you sell just the module?

asked by: Mike

Expert Reply:

You could use a non-vehicle specific powered converter like # C59496 and splice it into the current t-connector and 12-volt feed.

Typically a taillight converter will go bad because of a short in the trailer wiring, so before replacing the converter you'll want to closely examine the wiring on your trailer. Start at the trailer connector and follow each circuit back to the lamps. Look for pinched wires, loose connections, cracked or worn wire insulation-anything that would let the copper conductor short out on the trailer frame. Pay special attention to points where wires pass through or sit on frame members. Also check the bulb sockets to make sure they're not corroded.

expert reply by: Mike L