Does Camera on Voyager WVOS541 Camera System Need to Be Installed on RV Before Pairing to Monitor

Question:

Do I need to install the camera before pairing?

0

Expert Reply:

Yes, the camera needs to be connected to power and ground before starting the pairing process with the monitor, as outlined in the attached installation instructions for the Voyager WiSight Wireless RV Backup Camera System # WVOS541. That being said, when you start the pairing process, the monitor needs to be powered up first. The camera should not be powered up until the 4th step. Otherwise, the pairing will fail.

Pairing Process:

1. Monitor must be connected to 12 Volt DC power supply.
2. Press the SELECT/PAIR button on the front of the monitor expected mode & select the appropriate AV source (AV1-AV4)
3. Press and hold the "SELECT/PAIR" button on the front of the monitor for 5 seconds and release. (Monitor will display "PAIRING START")
4. Apply 12 Volt DC power to the camera.(Camera 1 - Camera 4 corresponding to Monitor's AV1 - AV4)

If done correctly, monitor will display "SAVE DATA". If pairing is not successful, the
monitor will display "PAIRING FAIL". if you receive this message, repeat steps 3-4.

expert reply by:
0
Carla M

Product Page this Question was Asked From


Follow up Questions

Similar Expert Q&A Pages

See More Q&A Expert Answers >>