Trailer Lights Stay On After Tow Vehicle is Shut Off  

The Hopkins #HM11143395 you've looked at is the correct replacement 7-way for your 2007 Toyota Tundra. The installation is pretty simple, you can see the procedure by clicking the provided link and viewing the video showing the harness being…

It sounds as though there is a short or something is mis-wired. Using a circuit tester, like the #PTW2993, check the connection points in the vehicle side connector, to see if there is constant power on the running light circuit (brown wire on the…

I suspect your problem is caused by a damaged or corroded trailer connector. Take a look at your trailer connectors, both the socket on your truck as well as the plug on the trailer. Look for green or white corrosion on the pins or sockets of the…

This sounds like the problem could be a short or possibly ground related but based on what you have said a ground is much less likely. Look for any pinched or frayed wires on the trailer and fix as needed. This could cause a short resulting in…

With your plug-in trailer wiring harness, the Curt T-Connector Vehicle Wiring Harness part #C56274 on your 2018 Jeep Renegade then you will need to test the running light circuit leaving the converter box. If this wire has power while the…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

Actually, the P3 now has the upgraded axis accelerometer like the P2. The Tekonsha P3 Trailer Brake Controller #90195, will work with both electric over hydraulic brakes on the trailer as well as electric brakes. It has a menu option on the display…