Product Experts Available Now!
Call 800-298-8924
The Retracted Height from the Bottom of the Wheel to the Mounting Bracket on a Dutton Lainson Jack
Question:
What is the retracted height from the wheel bottom to the center of the mounting bracket?
asked by: Allison
0
Expert Reply:
I went out into our warehouse and pulled a Dutton Lainson Jack # DL22800 to measure the distance from the bottom of the wheel to the center of the mounting bracket when retracted and found that distance to be 13 inches.
Check out the video I attached that shows me taking this measurement.
I attached a link to an FAQ article on trailer jacks for you to check out also.
expert reply by: Jameson C
0
Product Page this Question was Asked From
Pull Pin, Easy Swivel Trailer Jack with 8" Wheel - Sidewind - 1,500 lbs. by Dutton-Lainson
- Trailer Jack
- Side Frame Mount Jack
- Swivel Jack - Pull Pin
- Bolt-On
- 1500 lbs
- Sidewind Jack
- 10 Inch Lift
- No Drop Leg
- With Wheel
- Dutton-Lainson
more information >
Featured Help Information
Miscellaneous Media
Similar Expert Q&A Pages
- Trailer Jacks Manufactured in the USA
- Dimensions of Dutton-Lainson Replacement Wheel For Pull Pin, Easy Swivel Trailer Jack, 8 Inch Wheel
- Trailer Jack Replacement Recommendation for a 6,000 lb Snowmobile Trailer
- Will the Easy Swivel Trailer Jack # DL22800 Install Around a 3 x 5 boat Trailer Tongue
- Replacement Trailer Jack with Retracted Height Less than 15 Inches
- Replacement Parts for the Dutton-Lainson Sidewind Swivel Trailer Jack # DL22800
- Trailer Jack Recommendation for Trailer with Swivel Dutton Lainson Jack Installed
- Are there Instructions for the Internal Parts of a Swivel Trailer Jack
- Replacement Wheel Recommendation for Dutton Lainson Jack part # DL22800
- Trailer Jack Recommendation with Rubber Wheels for Manueverability
- Swivel Marine Jacks Manufactured in the USA
- Swivel Trailer Jack with a Wheel for a 2007 Viking Pop-up Camper
- Corrosion Resistant Trailer Jack for a Trailer with 2 Inch by 4 Inch Frame
- What is the Mounting Hold Spacing for Dutton Lainson 1500 Pound Swivel Trailer Jack
- Trailer Jack Recommendation that Allow Tailgate Clearance
- Pull Pin, Easy Swivel Trailer Jack Greasing
- Need Replacement Pull Pin Kit for Dutton-Lainson Swivel Jack on Midwest Trailer Model SLXR2314LW
- Will the Dutton-Lainson Trailer Jack # DL22800 fit on a 2-1/2 inch Mounting Hole Bracket
- Trailer Stuck to Truck and Jack Wont Crank
- Will the Bulldog Round, Snap-Ring Swivel Jack # BD151443 Fit on a 2 inch by 5 inch Trailer Frame
- Replacement Jack Handle for 1,000 Pound Dutton Lainson Trailer Jack
- USA Made Swivel Wheel Trailer Jack for Use in Saltwater
- Dutton-Lainson Trailer Jack # DL22800 Recommendation for a 3 inch by 5 inch Frame
- Should There be a Hole in the Dutton Lainson Jack part # DL22800
- What is the Overall Height of Dutton-Lainson Jack Part DL22800 when Fully Retracted
- What is the Wheel Made of on Dutton-Lainson Easy Swivel Trailer Jack