Can Curt 51110 Venturer Brake Controller Install in 1998 Jeep Grand Cherokee


Will this work on my 1998 Jeep Grand Cherokee Laredo 4.0L ?


Helpful Expert Reply:

Yes, the Curt Venturer part # C51110 can be used on your 1998 Jeep Grand Cherokee with a factory 7-way.

Next, for a wiring kit to install the brake controller to the 7-way you would want the Wiring Kit for 2 and 4 Brake Electric Brake Controllers # 5506. This will provide the power source and ground for the wiring for the brake controller. You will need to test the wires from the brake pedal switch of your vehicle to find a circuit that has voltage when the brakes are applied and none when not applied. This will be the circuit you will run the red wire to.

Finally you will need to run a length of 10 gauge wire (part # 10-1-1) from the brake output circuit of the controller to the brake output circuit of the 7-way (blue wire). The # 10-1-1 is sold by the foot so you will need to order a quantity of the amount of feet you will need.

I attached an FAQ on installing brake controllers for you to check out.

helpful expert reply by:
Jameson C

Products Referenced in This Question

Product Page this Question was Asked From

Follow up Questions

Similar Expert Q&A Pages

See More Q&A Expert Answers >>