Weight of etrailer.com Round Swivel Marine Jack # MJ-1200B

Question

Question:

Good afternoon, could you tell me how much it weighs? Thank you

asked by: Gaston

1

Helpful Expert Reply:

The etrailer.com Round Swivel Marine Jack w/ Wheel # MJ-1200B referenced in your question weighs just around 15 pounds.

This is a nice, corrosion-resistant swivel jack that features 11 inches of travel and a 1,200 pound lift capacity. The mounting bracket and hardware are included, along with the 5-3/4 inch wheel. I have attached a couple short video demonstrations on this swivel jack that you can also take a look at.

expert reply by: Chris R

1

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

Hey Rebecca! Information is limited and isn't finalized yet from Trailer Valet since the #TV83FR is still a preorder. However, I was able to find that the full height of the jack when it is retracted is 33" from the wheels to the top. I also…

view full answer...

Answer 3

Hey Rod, The Ark Xtreme Off-Road Jack w/ 2 Wheels #ARK99FR has multiple slots in the outer tube of the jack that the mounting bracket can slot into. In the bottom slot you'd be right around 9-1/2" between the ground and frame with the wheels…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Here is an image I have from the Xtreme Off-Road Swing-Up Trailer Jack #ORJW750D in zinc which will have the same dimensions as the black Jack #ORJW750BD you are looking at.

view full answer...

Answer 6

From what we have found, the Nissan factory brake controller harness has the following color/functions: Nissan Red to brake controller black for 12-volt power Nissan Red with green tracer to controller red for input from stoplight Nissan black to…

view full answer...

Answer 7

The nut on the spindle should be tightened until snug, with no side-to-side play in the hub and then backed off slightly, about maybe a 1/8 of a turn. If the spindle uses a castle nut and cotter pin or tang nut, tighten the nut finger tight until it…

view full answer...

Answer 8

If you are not wanting a bolt-on jack such as the Fulton XLT Bolt-Thru Swivel Trailer Jack, #F26ZR we have the Fulton F2 Adjustable A-Frame Jack, #F1413250334. The F2 Series jack is specially designed for use with Fulton's F2 A-frame coupler. If…

view full answer...

Answer 9

In regards to the Fulton XLT Bolt-Thru Swivel Trailer Jack part #F26ZR, the distance from the center of the mounting bracket to the top of the jack tube cap is 13.4". I have attached a photo below as well to show this. I spoke to Fulton and this…

view full answer...

Answer 10

The closest trailer tire size we offer to your 18.5x8.5x8 tire size would be a 215/60-8. This is essentially the same size as what you have. For a tire in this size you would want the part #AM1HP28. Check out the review video I attached as well.

view full answer...

Answer 11

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 12

It's possible. Here's Cargo Towing Solutions troubleshooting procedure for if the actuator won't run, or runs continuously: Verify that the trailer and tow vehicle are wired according to the electrical schematic shown below. Perform the…

view full answer...

Weight of etrailer.com Round Swivel Marine Jack # MJ-1200B

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching