Recommend Replacement Trailer Coupler For 3 Inch Channel and 2 Inch Ball
Question:
I need to replace my coupler on a shorelander trailer. It has a 3 channel. I need to fit a 2 ball and the mounting holes need to be 3 inches on center2.5 inches between the holes. What do you have that will fit?
asked by: Jim V
0
Expert Reply:
The item you selected, Master Lock Trailer Coupler, part # F223000301, has a bolt hole spacing of 3 inches from center to center. This coupler should work on your trailer if it has a 3 inch channel.
I walked out to our warehouse and measured a coupler with the same bolt hole spacing, Dutton-Lainson Trailer Coupler, part # DL13897. It measured approximately 2.5 inches between the holes and 3 inches from center of hole to center of hole.
expert reply by:
Reno H
0
Continue Researching
- Shop: Round Swivel Marine Jack w/ Wheel - Bolt On - Zinc - Sidewind - 10" Travel - 1,000 lbs
- Shop: Square A-Frame Jack w/ Footplate - Drop Leg - Sidewind - 28-3/4" Lift - 3,000 lbs
- Shop: Channel Tongue Trailer Coupler - Trigger Latch - Zinc - 2" Ball - Bolt On - 3,500 lbs
- Video: etrailer Adjustable Channel Couplers Mounting Bolt with Nut Review
- Video: Buyers Products Adjustable Trailer Coupler 337B9020 Review
- Q&A: Can Flat Bed Directly Tow with Bumper
- Q&A: Recommended Coupler Lock To Lock Demco Surge Brake Coupler DM8104311 To Tow Vehicle
- Q&A: Trailer Jack for Trailer With Non-Traditional Trailer Tongue
- Video: Master Lock Trailer Coupler Locks - Latch Lock - 2847DAT Review
- Video: Fulton Fas-Lok Coupler Review
- Video: etrailer Channel Tongue Trailer Coupler Review
- Search Results: safety chains
- Search Results: trailer hardware
- Search Results: mounting hardware
- Search Results: hitch hardware
- Shop: Replacement Mounting Bolt with Nut for Adjustable Channel Couplers - 5/8"
- Shop: Round A-Frame Trailer Jack - Sidewind - 15-5/8" Travel - 5,000 lbs
- Shop: Drop Leg for etrailer and Ram Jacks - 13-1/4" Tall - 5-1/4" Diameter Footplate - Zinc
- Shop: Buyers Products 3 Position Channel and 5 Position Channel Bolt and Nut Kit
- Search Results: coupler hardware
- Search Results: chain
- Search Results: safety pin
- Video: etrailer Trailer Jack - A-Frame Jack - TJDA-5000S Review
- Article: Trailer Wiring Diagrams
- Shop: Trailer Hitch
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Shop: Trailer Wiring
- Video: Choosing the Right Trailer Wiring
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Trailer Tire Sizing
Dominic P.
7/22/2020
for Item DL13897 , I know holes on the side are 3 inches appart, but from the inside ''top'' where the 3x3 tubing seats what is the distance from that plane to the center of the holes on the side ? In other words, if I measure from the top of the 3x3 tubing where the coupling is mounted to the center of the side holes , what is the distance ?