Are the Races Pressed Into the Hub
Published 04/10/2017 >
Products Featured in This Question
Question:
Does the hub come with the races already press into the hub?
asked by: Brandon
1
Helpful Expert Reply:
Yes, the races come pressed in the hub. You will only have to insert and pack the bearings (check out part # L70025) and press in the grease seal. A hammer and a small block helps when tapping in the grease seal. We also have a 7-Piece installation set, part # PTW83020, that comes in handy if you do your own trailer maintenance.
expert reply by:
John H
1

Product Page this Question was Asked From
Trailer Idler Hub Assembly for 2,000-lb Axles - 5 on 4-1/2 - Galvanized
- Trailer Hubs and Drums
- Hub
- Standard
- L44649 / L44649
- Marine Grade
- For 2000 lbs Axles
- 1/2 Inch Stud
- 5 on 4-1/2 Inch
- 10 Inch Wheel
- 12 Inch Wheel
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Hubs For EZ Loader Trailer With 2,500 lb Axles
- Article: Trailer Tire Sizing
- Q&A: How to Tell if Trailer has a BT8 or BTR Spindle Installed
- Q&A: What Is the Difference Between a BTR and BT8 Spindle
- Q&A: Replacement Trailer Hub for 2016 Tail Trailer Model PST2000
- Q&A: Correct Bearing Kit for a Lippert Trailer Idler Hub Part 122098
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Changing from Oil Baths to Bearing Buddies on an EZ Loader Boat Trailer
- Q&A: What is the Inner Diameter of Trailer Bearings L44649 and L68149
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Most Popular Wheel Bearings
- Article: How to Measure a Trailer Axle
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision