How Many of the Andersen Camper Wheel Chocks is Needed to Prevent Trailer from Moving  

Hi Trevor, The Kenda Karrier ST205/75R15 Radial Tire w/ 15" Silver Galvstar Wheel #KE66JR does not come balanced though you can add balancing beads to the tire if you'd like. If you have a single axle trailer you can balance them with two of…

The three radial special trailer (ST) tires we offer in size 215/75-14 can be seen on the linked page. These include the Taskmaster #TTWTRTM2157514D in Load range D, the Provider #TTWTR21514 in Load Range C and the Kenda Karrier #AM10229 also in Load…

Our trailer wheel and tire combos come from the manufacturer mounted. As trailer tires do not require balancing most manufacturers will not balance their tire packages like the Kenda Karrier ST205/75R15 Radial Trailer Tire with 15" Black Mod…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…